Table of Contents. 1 Introduction 11 Features 12 Package Contents 13 Product Overview Getting Started 21 Inserting the Memory Card 22 Installation Adjust Device Post ion to Power ~ w Using the Car Dash Camera 3.1 Recording Videos 32 Recording Screen 312 Ting a Snapshot 313 Audio Recording 314 Playback Videos & Photos 315 Deleting Video & Photo Ties 316 Enable WI-F 313 Driver Safety Alerts 4 WI-Fi Setup and Companion App 4.
Thank you for buying the RL. car dashboard. Protect you and your vehicle with real-time video and audio recording while you're driving. Please read this manual carefully before using this product We hope you enjoy using this product. 11 Features WiFi 2304x1296P Resolutions (Front Camera Only) + 2.7" LCD Color Screen * Un to 155-degree wide angle ens G-Sensor Motion Detection « Parking Mode + Audio Recording 1.
13 Product Overview €) Reset Button ©) Power Button €) Micro 5D Card Riot ©) Rear Camera Port (Min USB} © Suction Cup Mount Slot 0Q Lem €) Power/Data Port (Micro USB) © Menu Button © Up Button © Down Button ok Button ©) speaker ® Mic @ Rear Camera © Rear View Lens 0) Rear Camera Port {Mini USB}
PAT FRE] 2.1 Inserting the Memory Card Insert the memory card, with the pins facing towards the back of the device, until it clicks into place. Storage Canad lice Recording Time 1668 2.5 Hours 32GB 5 Hours 64GB 10 Hours 128GB 20 Hours 25668 40 Hours For reference only front + rear camera recording at 1080P Remove Memory Card Push the edge of the memory card inward until you fee! it click. then allow it to push out until you can remove it from the slot.
2.2 Installation Please follow the below instructions for mounting your dash cam to the windshield of your vehicle: Front Camera Installation L Sic the car mount nits tha sot on top of the device unit a cock sound is healer 2 Connect the dash camera to the power outing your car, (see 24) 3.Tum the camera on, whilst looking at the display screen, find a suitable: location for installing your dash cam on your windshield.
. Trace the cable down the side of the door frame ta the floor of the vehicle. Then Sift the carpet in the passenger side foot well and trace the cable beneath this. 8 Alternatively, route the power cable down the door frame and tuck it behind/ below the glove bax. Use the cable pics if reacquire. 9. Bring the cable out by the center console to the lighthearted power socket.
Note: Consult your vehicle's technical manual or consult a professional if you are not sure how to remove interior panels. 2.3 Adjust Device Position 1 Loosen the nut to swivel the device vertically. Click into place and secure by tightening the nut. 2 Swivel the device horizontally for a clear view. 24 Connecting to Power Use only the supplied car adapter to power the dash cam and charge the butt-in batter ry. L Plug ane end of the USB charging cable Into the Min USB port on the dash camera 2.
Manual Power + To manually tum the power on, press and hold the Power’ Button (2) for up to 3 seconds. + To manually tum the power off, press, and hold the Power Button (2) for 3 seconds. 2.5 Set Date & Time Before using the device, we recommend you set the correct date and time: L If the device is recording, short press the ‘OK’ button (1) to stop recording, and enter Standby Mode. 2 Press the "Menu button (8) to enter the General Settings menu. 3.
2.7 Default Settings wu Otto rats [Dim CN Heston | I0NPYI0NIR, 106P 000 | 2060+ GBP | 12060106 | 2967 PUBIS | 10989 +1060P Subcontractor | Oot Loop Regard | Inseminates ae [ame smi mh Data Sharp | OORT Dos Cockatoo Oflminrimardm | min nin aims Fr) Gone | OfiwNomaigh [Nona [Normal [Low Ho Logotype | OWI Parking Moe _| Ovo San AON | Discriminating [ans | rin or Fr) =) ovo There are three preset scenario modes for everyday driving, scenic driving or when the vehicle Is parked.
3 Using the Car Dash Cam: 3.1 Recording Videos With an SD card inserted and the device connected to power, when the car engine is switched on, the dasher automatically powers on and starts recording, When the vehicle engine is switched off, the dasher will automatically save the recording and power off within 10 seconds. Alternatively, short press the ‘0K button (L1) to stop/start video recording manually. 3.
‘While the dash caner is in standby @ 1 Pause 8 Settings 2 Resolution 9. Camera WOR 10. Payback 4, Parking Mode 11. Record 5. Motion Detection 12 Date Time 6. Audio Recording Status 13. Battery TWF 33 Adjusting the Settings Customize the video recording and other general settings via the on-screen display (OSD) menus: If the device i recording, short press the ‘OK’ button (L1) to stop and enter Standby Mode. L.
34 Adjust the Recording Resolution The resolutions can be adjusted in the general settings. The R1 dash camera supports 1296P and 1080P front camera recording and 1080F rear camera recording. The rear camera options wil only show when the rear cameras is connected to the dash camera. Front camera ony: ‘General Settings > Resolution > 1296P /1080P Front and Rear Camera: General Settings > Resolution > 1296P+1080P /1080P+ 10807 3.
3.8 Vibration Detection ‘The Vibration Detection feature senses for unusual impacts or collisions detected G Sensor. It automatically riggers the Emergency Video Set the sensitivity to automatically rigger these features with smaller or larger vibrations feature Gan also be muted Off. Gr sensor sensitive can by adjust from the: General Settings > Sensitivity > Off / Low Middle / High 3.
3.13 Audio Recording When the dash camera is recording the Audio Recording function can enabled or disabled by pressing tha up button (3). 3.14 Playback Videos & Photos L If the dash camera i recording, short press the ‘OK’ button {11} to stop and enter Standby Mode. 2. Press the ‘Down’ button (10) to enter Playback Mode. 3, Press the ‘Up’ and ‘Down’ buttons select between Normal Video, Emergency Video or Photo. Press tha ‘OK’ button (11) to select or press the ‘Menu’ button (8) to rectum to standby mode.
3.18 Key Tone Enable the Key Tone function to have a chime sound when pressing the keys on the dash camera. General Stings > Kay Tone > Off / On 3.19 Driver Safety Alerts The dash camera has a Driver Fatigue Alarm and Light Reminder alarms that can be sat to aid the driver. The Driver Fatigue Alarm can be muted off or set hours to remind the driver to take a break on longer journeys.
4.1 WI-Fi Application Functions Video Full Screen Toggle the video view between full and half screen Camera Item Ridership 1 |Back Arrow Return to the main screen 2 | Microphone Indispensable audio recording 3 | Video Camera con | Record a 10 second clip 4 | Compass Orientate map to North 5 | Connection Disconnect the app from the dash camera.
Mer Feat Dec Avail hon App Download [Display QR code to |download tha App. Scenario Mode (Set one of the preset | Default/Drive/Scenic/Park modes for different diving Scenarios. Resolution [Set the resolution of | Front Camera 1296P/L0B0P videocassette | Front & Rear Camera 1296p recorded.
Wynn | Fare Escritoire Ava liable root Screen Stamp | Add/remove a date and | Of/On time stamp and Logo Stamp. Visible on saved video recordings and photos. Driving Safety | Driver Fatigue alarm | Driver Fatigue Oft/One and Light Reminder. | hour/Two hours/Four hours Light Reminder oft/on Motion Detection | Enable/disable motion | Motion Detection/ Mode detonation and parking | Parking Moderation made.
6 FAQs ‘Where should I place the dash cam? + We recommend that you mount the car dash cam as close to the canter of the windshield as possible. This should neither distract the driver nor block the drivers view (see 2.2). Why does the dash cam stop recording after some time? + If motion detection is enabled, the dash cam will automatically stop recording whee no movements & detected for more than 15 seconds (see 3.7). + Your micro SD card may be full and need to be formatted before using again.
FATE TE RTT For customer support inquiries please contact: Or visit our website: WWW -edge.com oe acebookeomoeroedlgeta/ o piterestomrermedgeGA witiercom/zeroedgeGA you tube comfortable Follow ust get the ate upends. Thank you for chasing 2-EDGE Your satisfaction is always our first priority. AI Z Edge customers have a 30-day money back guarantees, tn make sure your shopping experience is quarry-free. By default, the unit warranty period is set to 12 months from the unit shipped date.
9 Product Specifications fe Descriptor Image Sensor COS sensor INX307+GC2053 Resolution 1296P + 1080P 30PPS. Storage Media Supports Micro SD, up to 25668 Class 10 or above Display 27° TFT LCD 960240 Lens ‘Wide Angle Iced Focus lens Battlefront) 155 Degrees, 110 Degrees Til Image (Photo Mode) | Sensor Resolution: 2M _ Format.
FCC Statement This equipment has bean tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
