Z-Vent Single Wall AL29-4C Special Gas Vent Z-Vent Single Wall AL29-4C Gas Vent Technical & Dimensional Data Z-Flex ® Canada: 452 Attwell Drive, Etobicoke, ON M9W 5C3 tel: 416.679.0045 • fax: 416.679.0051 Chimney & Venting Solutions U.S.A :20 Commerce Park North, Bedford, New Hampshire 03110 tel: 603.669.5136 • fax: 603.669.0309 • 800.654.5600 www.z-flex.com sales@z-flex.
Z-Vent Single Wall AL29-4C Special Gas Vent Contents Page No Adapter Double Female Drain Pipe Vertical in-line Drain Tee Horizontal Drain Tee Vertical 15 15 13 13 Elbows 45 deg. Elbows 90 Deg.
Z-Vent Single Wall AL29-4C Special Gas Vent Pipe Available in diameters 3in to 24in and standard lengths up to 10ft (3in and 4in diameter only). Pipe can be cut to length. The female end of each Z-Vent component incorporates a silicone sealing gasket. Examine all components to ensure that gasket integrity has remained during shipping. Gaskets must be in proper position or flue gases could leak resulting in carbon monoxide poisoning.
Z-Vent Single Wall AL29-4C Special Gas Vent Tees Tee Cap with Drain A tee is used to connect horizontal and vertical vent sections A B C Part Number Description 5 10.5 6.5 2SVST05 Z-Vent Tee 5in 6 10.5 6.5 2SVST06 Z-Vent Tee 6in 7 12.5 7.5 2SVST07 Z-Vent Tee 7in 8 14.5 8.5 2SVST08 Z-Vent Tee 8in 10 18.5 10.5 2SVST10 Z-Vent Tee 10in 12 20.5 10.5 2SVST12 Z-Vent Tee 12in 14 22.5 12.5 2SVST14 Z-Vent Tee 14in 16 24.5 13.5 2SVST16 Z-Vent Tee 16in 18 26.5 14.
Z-Vent Single Wall AL29-4C Special Gas Vent 45° Elbows 90° Elbows 45° elbows are used when a direction change or offset is required. A B C Part Number Description 3 3.5 2.25 2SVEEWCF0345 Z-Vent Elbow 45° x 3in 4 4 2.50 2SVEEWCF0445 Z-Vent Elbow 45° x 4in 5 4.5 2.50 2SVEEWC0545 Z-Vent Elbow 45° x 5in 6 4.75 2.75 2SVEE0645 Z-Vent Elbow 45° x 6in 7 5 4 2SVEE0745 Z-Vent Elbow 45° x 7in 8 5.
Z-Vent Single Wall AL29-4C Special Gas Vent Low Resistance Rain Cap Rain Cap A low resistance rain cap is designed to terminate a vertical stack and prevent the entrance of debris or rain into the vent. It also provides low resistance to flue gas flow. A B C Part Number Description 5 5 10 2SVSRC05 Low Resistance Rain Cap 5in 6 5.5 11 2SVSRC06 Low Resistance Rain Cap 6in 7 6.5 13 2SVSRC07 Low Resistance Rain Cap 7in 8 7.
Z-Vent Single Wall AL29-4C Special Gas Vent Lateral 45° Wall Termination A lateral 45° is designed to allow a low flow resistance connection of horizontal and vertical sections. A tee cap is available separately. A B C Part Number Description 5 13 12 2SVSL0545 Z-Vent Lateral 45° x 5in Tee 6 14 13 2SVSL0645 Z-Vent Lateral 45° x 6in Tee 7 15.5 14.5 2SVSL0745 Z-Vent Lateral 45° x 7in Tee 8 17 15 2SVSL0845 Z-Vent Lateral 45° x 8in Tee 10 20 17.
Z-Vent Single Wall AL29-4C Special Gas Vent Increaser Used to upsize a vent system Reducer Adjustable 18in A B C Part Number Description 3 4,5,6 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 4 5,6,7 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 5 6,7,8 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 6 7,8,10 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 7 8,10,12 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 8 10,12 10 2SVSI0(A)0(B) Z-Vent Increaser(A)to(B) 10 12 10 2SVSI0(A)0(B) Z-Vent
Z-Vent Single Wall AL29-4C Special Gas Vent Flashing Flat Flashing 0-30° Flat flashing provides weather protection where the vent penetrates the roof or chimney. Use on flat or slightly sloped (5° slope maximum) roofs.
Z-Vent Single Wall AL29-4C Special Gas Vent Wall Thimble B A Storm Collar For use when the vent passes through a horizontal opening. Not required for non-combustible walls. A B Part Number Description 3 5 2SVSWTX03 Z-Vent wall thimble 3 in 4 6 2SVSWTX04 Z-Vent wall thimble 4 in 5 7 2SVSWTX05 Z-Vent wall thimble 5 in 6 18.625 2SVSWT06 Z-Vent wall thimble 6 in 7 19.375 2SVSWT07 Z-Vent wall thimble 7 in 8 20.375 2SVSWT08 Z-Vent wall thimble 8 in 10 22.
Z-Vent Single Wall AL29-4C Special Gas Vent Guy Band A guy band is used to stabilize the vent above the roof line or where a vent support can not be used. Secure with 4 guy wires ( not included).
Z-Vent Single Wall AL29-4C Special Gas Vent Vent Support Base Support Vent supports are used to provide support to the vent system while maintaining proper clearance to combustible materials. As vertical supports are required after any 10 foot run. These supports may also be used to support long horizontal runs, which require support every 6 feet. A B C Part Number Description 3 4 5 6 7 8 10 12 14 16 18 20 22 24 2.5 3.0 4.5 5 5.
Z-Vent Single Wall AL29-4C Special Gas Vent Horizontal Drain Vertical Drain Tee Extended Wall Thimble Termination Tee B A horizontal drain pipe is used to drain condensate from the vent system. The drain should be positioned as close as possible to the appliance and vent sloped towards it. A B C Part Number Description 3 9 2 2SVEDWC03 Z-Vent Horizontal Drainpipe 3” 4 9 2 2SVEDWC04 Z-Vent Horizontal Drainpipe 4” A vertical drain pipe is used to drain condensate from the vent system.
Z-Vent Single Wall AL29-4C Special Gas Vent Termination Elbow Termination Hood* Used to terminate a horizontal vent A B Part Number Description 3 2 2SVSTEX0345 Z-Vent Termination Elbow 3 x 45 3 2 2SVSTEX0390 Z-Vent Termination Elbow 3 x 90 4 2 2SVSTEX0445 Z-Vent Termination Elbow 4 x 45 4 2 2SVSTEX0490 Z-Vent Termination Elbow 4 x 90 Used to terminate a horizontal vent section A B C Part Number Description 3 5.75 2 2SVSHTX03 Z-Vent Termination Hood 3in 4 5.
Z-Vent Single Wall AL29-4C Special Gas Vent Steep Roof Flashing Vertical Drain Pipe Adapter 6in (Double Female) Used where a vertical vent section passes through the roof. Accommodates roof pitches from 40° to 90° - 8/12-12/12. Storm collar sold separately. A B C Part Number Description 3.25 16 16 2SVSADJS03 Steep Roof Flashing 3in 4.25 16 16 2SVSADJS04 Steep Roof Flashing 4in Used on vertical runs to drain condensate from the system.
Z-Vent Single Wall AL29-4C Special Gas Vent Weil-Mclain Adaptor A B C Part Number Description 3 4.25 3.25 2SVEMGVX03 Weil-Mclain GV Starter 3in (Series 2) Weil-Mclain CGI Adaptor Weil-Mclain Starter Tee Series 3/4 Adaptor Safety Vent Adaptor A B Part Number Description 3 3 2SVEWMFAF03 Weil-Mclain CGI Adaptor 3in A B C Part Number Description 3 5.5 7 2SVEVSTF03 Weil-Mclain Starter Tee 3in (Series 3 & 4) A B C Part Number Description 3 5.5 3.
Z-Vent Single Wall AL29-4C Special Gas Vent Buderus Adaptor A B Part Number Description 3 4.25 2SVB03 Z-Vent Buderus GA 124 244 4 4.25 2SVB04 Z-Vent Buderus GA 124 244 Burnham, Triangle Tube Adaptor Ametek Fan Adaptor Locking Bands A B Part Number Description 3 4 2SVSTA03 Burnham PV2/ Triangle Tube Adaptor A B Part Number Description 3 4.
Z-Vent Single Wall AL29-4C Special Gas Vent Modine Adaptor A B Part Number Description 4 4 2SVMPE04 Z-Vent Modine PDP 125 Adaptor 4in Slant Fin Victory, Concept, VSPH Adaptor Stant Fin Termination Adaptor Smith/Hydrotherm Adaptor A B C 3 5.5 4 Part Number Description 2SVSSLA2 Slantfin Victory, Concept, VSPH Adaptor A B C Part Number Description 3 6 1.
Z-Vent Single Wall AL29-4C Special Gas Vent Sta-Rite Adaptor Utica Adaptor Viessmann Vitoden Adaptor Viessmann Vitogas Adaptor A B Part Number Description 4 8.25 4STPHA04 Sta-Rite Connector A B Part Number Description 3 3.75 2SVSUBAF03 Utica Boiler Adaptor 3in 4 3.
Z-Vent Single Wall AL29-4C Special Gas Vent Bosch Adaptor Noritz Adaptor Adaptor Aerco A B Part Number Description 4 4 2SVFX04 Bosch 125 FX Adaptor 4in A B Part Number Description 4 6 2SVWA03 Z-Vent Adaptor Noritz 3in 4 6 2SVWA04 Z-Vent Adaptor Noritz 4in 4 6 2SVWA05 Z-Vent Adaptor Noritz 5in A B C Part Number Description 8 13.5 11.75 2SVAER0890 Adaptor Aerco 8 X 90 Canada: 452 Attwell Drive, Etobicoke, ON M9W 5C3 tel: 416.679.0045 • fax: 416.679.0051 U.S.
