Install Instructions

Note 1: These clearances apply except if the listing of an appliance speciﬁ es dif-

ferent clearance, in which case the listed clearance takes precedence.

Note 2: These clearances apply except if a listed wall penetration assembly is

used.

13. Ensure access to clean out Tee are in accordance with the enforcing authori-

ties and clearances are maintained to your local building codes.

INSTALLATION PROCEDURE

1. Unroll the Flexible Liner to the maximum allowable length. Take a rope

slightly longer than the liner and make a knot at one end of the rope and

place other end through the backside of the Nose Cone and pull the rope until

the knot is completely in the Nose Cone. Place the Nose Cone at the end of

liner. To secure, use duct tape or other fastener.

2. Guide the liner down the chimney (Nose Cone ﬁ rst) using the attached rope,

to the inlet opening. (see illustration A, on next page.)

3. Insert the vertical portion of the Base Tee (if used) into the inlet opening

with the capped end pointing down. Remove the Nose Cone from ﬂ ex liner

and fasten liner to an “A” Connector using large head stainless steel rivets

(1/8” size) (use 3 rivets). Fasten the “A” Connector to the top inlet of the

Base Tee using large head stainless steel rivets (use 3 rivets). To join two

parts by rivet, drill 3 holes, 9/64”) through the two parts. Then, fasten the

rivet by using either hydraulic (mechanical) or pneumatic riveter. Use three

(3) rivets. (see illustration B, on next page.)

4. Install the horizontal portion of the Base Tee and secure it with two (2) screws

through the attached brackets. Using a standard mortar mix, cement around

the horizontal portion of the Base Tee (or mortar guard) at the inlet.

TYPICAL INSTALLATION

MORTAR

GUARD

FLEX ONLY

SINGLE TEE DOUBLE TEE

(preferred method)

– 4 –