Instructions / Assembly

Page 5 of 11
3. Next, install Lock N Go Tee Base onto liner. Insert liner into top of tee and snug up on gear clamp
around liner. The branch will be installed later. Note: “IF” Insulation Blanket is used
- Peel
back the insulation in order to make a direct connection between the gear clamp of the fitting
to the liner, then re-cover.
4. Now the Flexible Liner is ready to be installed in the chimney. Take a rope slightly longer than the
liner and make a knot at one end of the rope and place other end through the backside of the Nose
Cone and pull the rope until the knot is completely in the Nose Cone. Place the Nose Cone at the end
of liner or bottom of ‡ Lock N Go Tee. To secure, use duct tape or other suitable fastener.
5. Guide the liner down the chimney, Nose Cone first, using the attached rope to the inlet opening.
Align opening on base of Lock N Go tee with chimney inlet. Remove Nose Cone through available
opening.
‡
NOTE: LOCK N GO TEE NOT REQUIRED WHEN INSTALLING WITH
FIREPLACE INSERTS. USE A INSERT CONNECTOR
. (See Fireplace Insert Installation
below & Typical Installation # 3)