Instructions / Assembly

9
8
9
8
1)Using bolt (A) through the holes of Smokestack(10) and the holes of Smokestack
Insulation Cotton(11), attaching two bolts(A) to the hole of Grill body, then
attaching Gasket(G) and nuts(H) , using wrench to tighten them.
1)Keep the Lid(4) open, attach Bolt(A) through Gasket(G), then installing handle(6) to Lid(4).
Repeat the above steps on the other side.
2)Using wrench to tighten them.(Do not over tighten these Bolts)
INSTALLING CHAMBER HANDLE TO LID:
ATTACHING HOPPER HANDLE TO HOPPER LID:
1). Keep the Hopper Burner Lid(44) open. Penetrate the Bolt(F) into the hole
on the Hopper Burner Lid(44), then install the Hopper Lid Handle(24) by screwdriver.
ATTACHING LATERAL FLAT PALLET AND FRONT FLAT PLATE:
1). Penetrate the 6 Bolts(B) through the Front Flat Plate Bracket(14)(17).
2). Penetrate the Step Screw(C) through the Front Flat Plate Bracket(14) and Spring Washer(E),
attaching Cap Nuts(D) then use screwdriver and wrench to tighten them. Repeat the above
steps on the other side.
ATTACHING THE SMOKESTACK AND CHIMNEY CAP:
3). Penetrate the Bolts(B) through Hopper Handle(43), tighten it with screwdriver.Penetrate the
Bolts(B) through the holes of the right side of grill and Lateral Flat Plate(22),
tighten it with screwdriver.