Installation Guide

11
4.ATTACHING THE SMOKE STACK AND CHIMNEY CAP
1.Place Smoke Stack Gasket (15) over the Smoke Stack Assembly (14), then assemble the
Smoke Stack Assembly (14) from the inside of the grill chamber.
2.Use Bolt (C) through the holes of Smoke Stack Assembly (14) and Smoke Stack Gasket
(15), align the hole of grill body, then attach the Hexagon Bolt (D). Finally use Wrench (B) to
tighten them. As shown.
3.Tighten the Chimney Cap (13) on the Smoke Stack Assembly (14). Note that the chimney
is vertical and then tightened.
5.ATTACHING THE SIDE HANDLE
Remove the Bolt and Gasket assembled on the Side Handle (9). Use the Bolt to pass
through the Gasket, the Handle Guide (10) and the Side Handle (9). Use Wrench (B) to
tighten.