Installation Sheet

ManualsBrandsZ-Lite ManualsBathroom LightsNori 4 Light 32" Wide LED Bathroom Vanity Light

Assembly and Installation Instruction

Warning!!! Shut Power Off At Fuse or Circuit Breaker .

1. Carefully unpack your new fixture and lay out all the parts on clear area. Take care not to lose any small

parts necessary for installation.

2. The Universal Crossbar contains several pairs of threaded holes. Find the pair of holes that match the

holes spacing in your fixture Wall Plate, and thread the two Fixture Mounting Screws part way into the

Universal Crossbar and tighten with two Hex Nuts.

3. Secure the Universal Crossbar to the Outlet Box by threading the two Outlet Box Screws through the

Key Holes.

4. Connect the fixture wires to the Outlet Box wires as follows. Connect the White Fixture wire to the

White Supply Wire, Connect the Black Fixture Wire to the Black Supply Wire. Make sure all wire

Connectors are secure and do not easily pull off with the slight tug. If there is no Green Ground Wire

from the Outlet Box, Connect the Fixture Ground Wire to the Cross Bar with the Green Grounding

Screw provided.

5. Once all wires are connected, tuck them carefully into Outlet Box.

6. Place the Wall Plate over the Fixture Mounting Screws, so it protrude through the hole in the Wall

Plate .

7. Thread the Finial onto the Fixture Mounting Screws and continue turning until the Wall Plate is snug

against the wall .

8. Slide Glass Shade Washer and Socket Ring onto Socket, and use Socket Wrench to secure Glass shade

and Socket Ring. Install Bulb to Socket

9. Return the power to the Outlet Box and test fixture. Your installation is now complete.

10. DIRECTION FOR USE

Protect the lamp from drops, hits and avoid use over 110% rated voltage.

Don’t touch the bulb while the lamp is burning or immediately after it has been put out. The

temperature of sealed molybdenum foil portion shall not exceed 350C.

Use the lamp in the specified direction. Don’t touch the bulb with finger. The finger marks left on the

bulb should be wiped off with alcohol, otherwise it may discolor the bulb slightly lowering the lamp

and fixture output.

Socket Wrench

Outlet Box

Fixture Mounting

Screw

Outlet Box Screw

White Fixture

Wire

Black Supply Wire

Supply Ground Wire

Hex Nut

White Supply Wire

Universal Crossbar

Wall Plate

Fitter

Socket

Glass Shade

Socket Ring

Bulb

Washer

Finial

Summary of content (1 pages)

PAGE 1
Assembly and Installation Instruction Warning!!! Shut Power Off At Fuse or Circuit Breaker . 1. Carefully unpack your new fixture and lay out all the parts on clear area. Take care not to lose any small parts necessary for installation. 2. The Universal Crossbar contains several pairs of threaded holes. Find the pair of holes that match the holes spacing in your fixture Wall Plate, and thread the two Fixture Mounting Screws part way into the Universal Crossbar and tighten with two Hex Nuts. 3.