Installation Guide
INSTALLATION INSTRUCTIONS
Model 569CHXL
Fig.1
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(
Ground)
Ground)
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear
as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
2. Place lock washer (C) over end of nipples (E)
protruding through crossbar (A) and thread hex nut (D)
onto nipples (E) until tight. Take this crossbar assembly
and mount to ceiling outlet box screws (B). Tighten
screws securely with screwdriver. The side of the cross
bar marked “GND” must face out.
4. Use a pair of pliers to open one end link of the chain
provided and connects to the fixture loop (J). Close the
link. By measuring, determine correct number of links
needed for proper hanging height. Using pliers
disconnect and discard remaining chain.
5. Lace the fixture wires through the chain. Slip loop collar
(I) over the chain, and then do the same with Canopy
(H).Open the other end link of chain and hang the
fixture on the loop at the ceiling. Close the link. Feed
the fixture wires through the loop (G) and the nipples
(E) and pull until taut.
6. CONNECTING THE WIRES (Fig. 2)
At this point, connect the electrical wires as follow:
Connect the smooth wire from the fixture to the black
(hot) house wire. Connect the ribbed wire from the
fixture to the white (neutral) house wire. Make sure all
wire nuts are secured. You may wrap the connections
with electrical tape. If your outlet has a ground wire
(green or bare copper). Connect fixture’s ground wire to
it. Otherwise, connect fixture’s ground wire directly to
the crossbar using the green screw provided. Tuck the
wire connections neatly into the ceiling junction box.
7. Finally screw the loop collar (I) to the loop (G) and
secure the canopy (H) to the ceiling.
8. Install the bulb (T bulb Medium base, not included.) in
accordance with the fixture’s specification.
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
Your installation is now complete. Return power to
the junction box and test the fixture