Installation Guide

INSTALLATION INSTRUCTIONS
Model 583CHB
Fig.1
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(
Ground)
Ground)
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear
as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old
fixture, including the mounting hardware. Carefully unpack
your new fixture and lay out all the parts on a clear area. Take
care not to lose any small parts necessary for installation.
2. Place lock washer (C) over end of nipples (E) protruding
through crossbar (A) and thread hex nut (D) onto nipples (E)
until tight. Take this crossbar assembly and mount to ceiling
outlet box screws (B). Tighten screws securely with
screwdriver. The side of the cross bar marked “GND” must
face out.
4. Adjust the Chain to your desired length by removing
links if needed.
5. Pull the supply wires through the Chain alternating
links. After the wires are through the Chain , pull the
Supply Wires and the Ground Wire through the Canopy Lock
Ring(J) and the Ceiling Canopy (H) in order.
6. Attach one end of the Chain to the Fixture Loop(L) with
one Quick Link (I). Lift the fixture and Chain up and attach the
other end of the Chain onto the Canopy Chain Loop (G) with
another Quick Link (I). The fixture will now hang safely.
7. Feed the Supply Wires and Ground Wire through the
Canopy Chain Loop (G) and Nipple (E) into the Outlet Box.
8. CONNECTING THE WIRES (Fig. 2)
At this point, connect the electrical wires as follow:
Connect the smooth wire from the fixture to the black (hot)
house wire. Connect the ribbed wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured. You
may wrap the connections with electrical tape. If your outlet has
a ground wire (green or bare copper). Connect fixture’s ground
wire to it. Otherwise, connect fixture’s ground wire directly to the
crossbar using the green screw provided. Tuck the wire
connections neatly into the ceiling junction box.
9. Raise the Ceiling Canopy (H)and Canopy Lock Ring (J) up
Chain and over the Canopy Chain Loop (G).Tighten the
Canopy Lock Ring (J) onto the Canopy Chain Loop (G) until
tight.
10. Install the bulb (E26 Medium base, not included.) in
accordance with the fixture’s specification.
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING! Your installation is now complete. Return
power to the junction box and test the fixture.