Installation Sheet

1 of 2
INSTALLATION INSTRUCTIONS
AModel 592S;593S;592M;593M
Fig.1
A B
C
D E F
I
H
J
G
Fig. 2
Fig. 3
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(
Ground)
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF;
EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
CAUTION: THE PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN THAT IS AWARE OF THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under
no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed
on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to
how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to miss any small
parts necessary for installation.
3. If you are replacing an existing fixture, remove and
disconnect the old fixture
4. Attach the mounting plate (B) to the outlet box (A) (Not
provided). Mark anchor holes location on the wall. Hit the
swell plastic button (D) (Not provided) into the wall with a
hammer.
Secure the mounting plate (B) to the outlet box with the
box screws (E), then use the mounting screws (C) to hold
the mounting plate 4 corners on wall. GND must face out.
Connect the electrical wires as follow: (Fig 2)
5. Connect Black wire from the fixture to the black (hot)
supply wire from outlet box; connect the white wire from the
fixture to the white (neutral) house wire from outlet box.
Make sure all wire nuts are secured properly. You may wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper). Connect fixture’s ground
wire to it. Otherwise, connect fixture’s ground wire directly to
the mounting plate using the green screw provided. Tuck the
wire connections carefully into the outlet box.
THE INSTALLATION (Fig.1)
6. Put the fixture back plate (F) onto the mounting plate
(B) to be secured with mounting screws (J).
7. Install the bulb (Not provided) into E26 Medium base in
accordance with the fixture’s specification.
Install glass shade (I). (Fig.4)
8. Install the glass shade (I) into the lamp holder and tighten
the fixture loop(G) with screws(H).
9. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. Indoor/Outdoor
Silicone Sealant) to outline the outside of fixture back
plate where it meets the wall leaving a space at bottom to
allow moisture a means to escape. (Fig. 3)
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
Your installation is now complete. Return power to
the junction box and test the fixture.
Caulking
Back plate