Manualshelf

Installation Sheet

ManualsBrandsZ-Lite ManualsLightingSheridan 17" Tall Outdoor Single Head Post Light
12
1 of 2
INSTALLATION INSTRUCTIONS
Model 594PHMS;595PHMS;594PHBS;595PHBS
INSTALLATION INSTRUCTIONS
Model 594PHMS;595PHMS;594PHBS;595PHBS
Fig.1
Post
Mounting Screw
Post Fitter
A
B
C
F
E
D
G
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper
(Ground
)
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the
old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
Wiring instruction
3. If you are replacing an existing fixture, remove and
disconnect the old fixture
4. Exposed the wires from the post or the pier mount
supporting the fixture, to make the wire connection
5. Connect the Black wire from the fixture to the black (hot)
supply wire from the post or the pier mount; connect the
White wire from the fixture to the white (neutral) wire
from the post or the pier mount, Connect the ground
wire from the fixture to the ground wire from the post or
the pier mount. Make sure all wire nuts are secured as
per (Fig 2). You may wrap the connections with electrical
tape.
6. tuck them carefully inside the post or the pier mount.
7. Place the fixture post fitter (A) onto the post or the pier
mount, and secure with the 4 mounting screws (B)
COMPLETING THE INSTALLATION (Fig. 1)
8.Install the bulb (D not provided) into E26 Medium base in
accordance with the fixture’s specification.
9.Install glass (F). (Fig.3)
Install the glass (F) on the cage and tighten it with cap
nuts (C)
10.Install top cover (G). (Fig.3)
Screw (E) the top cover to the cage
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. Return power to
the junction box and test the fixture

Summary of content (2 pages)