Installation Sheet

1 of 2
INSTALLATION INSTRUCTIONS
Model 596CHB;596CHM
Fig.1
A
B
C
D
E
F
G
I
H
J
I
K
M
N
L
Fig. 2
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
CAUTION: THE PRODUCT SHOULD BE INSTALLED BY A QULIFID ELECTRICAN THAT IS AWARE OF
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear
as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the
old fixture, including the mounting hardware. Carefully
unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts
necessary for installation.
2. Determine the length of Chain required to hang the
fixture at the desired height, using quick link (I) attach to
the fixture loop (K), remove or add Chain links as desired
at this time,
Lace fixture wire and ground wire up through every 3
links of Chain.
3. Thread the screw collar loop (G) onto the thread nipple
(E), and then, thread nipple (E) into the mounting strap
(A) and secure with hex nut (D) and washer (C)
4. Attach the mounting strap (A) to outlet box using two
box screws provided with the outlet box. Put the canopy
(H) over the outlet box secured with screw collar ring (J).
5. fasten the end link (I) of chain to the screw collar loop
(G). loose the screw collar ring (J) from screw collar loop
to slide down the screw collar ring (J), canopy (H) along
with Chain.
6. Insert the fixture and the ground wire through the
nipple (E), to make the wire connections as per (Fig. 2)
7. Connect the electrical wires as follow:
Connect the smooth wire from the fixture to the black
(hot) supply wire from outlet box; connect the ribbed wire
from the fixture to the white (neutral) house wire from
outlet box. Make sure all wire nuts are secured. You may
wrap the connections with electrical tape. If your outlet
has a ground wire (green or bare copper). Connect fixture’s
ground wire to it. Otherwise, connect fixture’s ground wire
directly to the crossbar using the green screw provided.
Tuck the wire connections carefully into the outlet box.
9. Raise the Canopy (H)and screw collar Ring (J) up to the
ceiling and secure in place by screwing the screw collar
ring (J) on the screw collar loop(G)
Glass panel Assembly (M). (Fig.3)
Insert the glass panel(M) into the slot in the top edge of
the cage, secure the glass panel (M) by pressing the cage
tabs onto the bottom edge of the glass panel.
10. Install the bulb into E26 Medium base in accordance with
the fixture’s specification.
Your installation is now complete. Return power to the
junction box and test the fixture
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(
Ground)
Ground)

Summary of content (2 pages)