GLIDER 20 USER MANUAL

Doc# 27-0006UM Issued 11/00 Rev 1.0
FINAL ADJUSTMENTS
Slide the Glider partially
out.
Use a flathead screw-
driver to slightly move
the Z-Locks in toward or
out from the Glider,
depnding on the need
for best fit. While
holding the Z-Locks at
the proper setting,
tighten the screws on
the Z-Lock mounts.
Install Glider
10
Go to the rear of the
cabinet to tighten the
slider extender rail
scews. If there is not
enough room to work
at the back of the
cabinet, the Glider may
need to be removed to
tighten the rail screws.
The Glider should now
slide in and out
smoothly. If not, repeat
these steps.
Because of variances in
cabinet frames, there
may need to be some
adjustments of the
Glider slide system for
best fit and movement
of the Glider in and
out.
If the Glider binds when
rolling in and out,
perform the following
procedures.
Slide the Glider in and
out several times. The
Glider should slide in
and out easily.
INSTALLATION TEST
The Glider should slide
in and out easily. If
not, adjust the position
of the two Z-Locks
again.
The Glider should easily
close completely.