User guide
MOUNTING METHODS
SELFADHESIVE INSTALLATION
Clean the surface with a suitable degreaser. Remove
the protective covering from one side of the double
sided adhesive pad and firmly apply to the back of the
device. Next remove the other cover and firmly press the
item onto the desired location. Do not use the adhesive
pad method of installation on a surface with peeling or
cracked paint, or on a rough surface.
SCREW MOUNTING
Remove the front of the device, and, if necessary, break
through the appropriate knockout (where the plastic is
thinner). Using the holes as a template, drill holes in the
surface and insert the wall plugs if fixing into plaster or
brick. WARNING, to prevent the alarm from activating
during installation, the siren must have its tamper
disabled and the control unit must be in ‘Walk Test’/
Program mode.
3.1 MOUNTING METHODS
WALL MOUNTING
Drill two holes in the wall surface and insert the wall
plugs if fixing into plaster or brick holes. Fix the screws
and hook the Zipabox onto the screw’s heads. Make sure
swivel antenna is in vertical position.
DINRAIL MOUNTING
Make enough space for Zipabox on your Din-rail. Hook
upper fitters on the back of your Zipabox to the Din rail
and press Zipabox slightly to snap lower fitters.
TABLE TOP
You can place your Zipabox on any table top. Just make
sure that swivel antenna is in vertical position.
3.0 INSTALLATION &
MOUNTING
Zipato provide two methods of mounting. Chose either the self-adhesive
pads or the screws and wall plugs supplied.
01
Holes for fixing
Zipabox on
screw’s heads
02
Upper fitters
03
Lower fitters
01 01
02 02
03 03
14
SMART ALARM USER GUIDE v1.1