User guide

If your Zipato Smart Alarm starter kit came with pre-
joined devices, then you can skip this chapter. Your
devices are already preprogrammed to work with
Zipabox in “Out of a box“ Concept.
RESET PIR MOTION DETECTOR
01. Click on Add device button in General window
02. From drop down menu chose Generic Z-Wave
03. Click on Reset button
04. Follow on screen instruction
05. Press Program Switch button on PIR motion
detector before countdown is over. If device reset
was successful next message will appear “Device
reset successful” and Join device button will appear.
Clicking on it will proceed to Join procedure
JOIN PIR MOTION DETECTOR
01. Start Zipato Control Center. In the window General
click on Add device.
02. In following window from drop down menu chose
generic Z-Wave
03. Chose Generic Z-Wave, click on Join button.
04. When discovery process starts press Program
Switch button on PIR motion detector before
countdown is over
05. If device is found the next two windows will appear
with a message, “device is found” and “Saving device”.
06. When message appear ”Device saved” click on “Close”
REMOVE PIR MOTION DETECTOR
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
03. When removing process starts, press Program Switch
button before countdown is over.
04. If device is removed successfully close window by
clicking on
button upper right corner.
6.0 CONNECTING
DEVICES
21
SMART ALARM USER GUIDE v1.1