User guide

RESET DOOR/WINDOW SENSOR
Before Door/Window sensor is added to Zipabox reset it
to delete any prior controller information.
01. Click on Add device button in General window
02. From drop down menu chose Generic Z-Wave
03. Click on Reset button
04. Follow on screen instruction
05. Press Program/Tamper Switch button on Door/
Window sensor before countdown is over
06. If device reset was successful next message will appear
“Device reset successful” and Join device button will
appear. Clicking on it will proceed to Join procedure
JOIN DOOR/WINDOW SENSOR
01. Start Zipato Control Center. In the window General
click on Add device.
02. In following window from drop down menu chose
generic Z-Wave and click on Join button.
03. When discovery process starts press Program/
Tamper Switch button on PIR motion detector before
countdown is over
04. If device is found the next two windows will appear
with a message, “device is found” and “Saving
device”.
05. When message appear ”Device saved” click on Close
button
Door/Window sensor can be seen in Sensors widget and
configured trough Total devices in General window
REMOVE DOOR/WINDOW SENSOR
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
03. When removing process starts, press Program/
Tamper
04. Switch button before countdown is over.
05. If device is removed successfully close window by
clicking on
button upper right corner.
If your Zipato Smart Alarm starter kit comes with pre-
joined devices, then you can skip thischapter as your
devices are already preprogrammed to work with Zipabox
in “Out of a box“ Concept.
22
SMART ALARM USER GUIDE v1.1