User guide

RESET RFID KEYPAD
01. Start Zipato Control Center.Click on Add device button
in General window
02. From drop down menu chose Generic Z-Wave
03. Click on Reset button
04. Follow on screen instruction
05. When countdown starts, press and hold the Tamper
switch for 2 seconds and release. If device reset
was successful next message will appear “Device
reset successful” and Join device button will appear.
Clicking on it will proceed to Join procedure step 04.
JOIN RFID KEYPAD
01. Start Zipato Control Center. Click on Add device
button in General window
02. In following window from drop down menu chose
generic Z-Wave and click on Join button.
03. When discovery process starts ( countdown ) Press
and hold the Tamper switch for 2 seconds and
release before countdown is over. If device reset was
successful next message will appear “Device
04. If device is found the next two windows will appear
with a message, “device is found” and “Saving
device”.
05. When message appear ”Device saved” click on
“Close” button
REMOVE RFID KEYPAD
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
03. When removing process starts (countdown), press
Tamper switch for 2 seconds and release.
04. If device is removed successfully close window by
clicking on button X located in upper right corner.
23
SMART ALARM USER GUIDE v1.1