User guide

7.1 GENERAL SECURITY PARAMETERS
Log in to Zipato online using owner’s credentials
and go to Security widget. The Security widget is the
management and control user interface for the Zipato
security system. It shows the current status of the
security system, and allows you to arm and disarm all
the security system partitions. Security widget acts as
advanced security panel. It consists of as many partitions,
as you create. Those partitions are like virtual alarms
allowing you to easier control your complete security
system. For example, you can create one partition for
your upstairs apartments, one for downstairs and one
for garage. Each of those areas could be accessed
completely independent of the other areas, so if you
armed your garage, you can still be present in your home
or vice versa.
To access your security widget, enter your 4-digit PIN
7.2 CREATE A NEW PARTITION
Partition is virtual security system. You can add unlimited
number of partition inside Zipato security widget. Using
partitions allows you to create separate alarm areas
inside you property so you can easier manage them all.
Consider each partition as separate alarm system with
its own settings and arm/disarm modes.
To add new partitions press
on security widget. In
GENERAL TAB you can set the following parameters:
ENTRY DELAY - how many seconds entry zone will
allow you to enter your code after it detects you. You
can also set a sound signal.
EXIT DELAY - how many seconds exit zone will allow
Once you finished with installation you can customize all aspect of your
security system to fits your needs.
7.0 SECURITY WIDGET
24
SMART ALARM USER GUIDE v1.1