User guide

ENTRY - check here if you want this zone to be entry
zone
EXIT - check here if you want this zone to be exit zone
REMOVE BYPASS - here you can disallow removing
bypass for this zone
FOLlOWER - check here if this zone is on the path to
exit or entry zone
SUPERVISION - check here if you want this zone to be
supervised
7.3 TESTING THE SYSTEM
Testing your system is an important part of the process
and will confirm that all the devices are within the range
and communicating with the panel.
PIR MOTION DETECTOR
When Presence detector detects movement the LED
status indicator on sensor will flash once. You will also
see red indicator on Zipato dashboard indicating sensor
has detected movement.
When no movement is detected for three minutes the
sensor will send the status of “OFF” and indicator
on Zipato dashboard will turn green again. Normal
operation, the LED will not light.
DOOR/WINDOW SENSOR
Opening the door/window to separate the magnet
from the sensor will send the status of “Open” to
Zipato and you will see red indicator on Zipato
dashboard indicating OPEN.
Closing the door/window to align the magnet with the
sensor will send the status of “Closed”. and the LED
will flash once. You will also see green indicator on
Zipato dashboard indicating CLOSED.
Normal operation, the LED will not light.
The ZD2102 sensor is equipped with tamper switch. If
the cover of sensor is removed, the door sensor will
send an tamper alarm signal to Zipato and the LED
will go solid.
RFID KEYPAD
After setting up your Security widget alarm system, test
your RFID keypad by arming or disarming alarm either
with a tag or code input method.
In order to test it, it first has to be configured. Go to Total
devices keypad Configuration tab.
There, 10 memory slots are available for memorizing
numeric or tag codes. Occupied memory slots will show
up under Security Users tab.
27
SMART ALARM USER GUIDE v1.1