User guide

ARMING THE SYSTEM
AWAY ARMING
Enter your PIN code and press OK.
Arm and Home can be selected by clicking on it. Select
‘Arm’.
Press OK. The exit delay is displayed and counts
down from the default setting of 30 seconds. The
control unit beeps (unless exit sound has been
switched off).
When the time is up, the control unit sounds a long
beep. ‘Alarm On’ is displayed and the system is armed.
The siren will beep once (if siren confirm has been
switched on), and the strobe will flash once after the
Exit Delay has expired.
HOME ARMING
Enter your PIN code and press OK.
You have a silent exit period in which to vacate the
armed area. This exit period is the same as used when
fully arming.
Click on Home button. Press OK. You can also put the
system into the home mode by using the keypad or
keyfob accessory.
PARTIAL BYPASS ARM MODE
The Partial (By-pass) Arm mode allows the user to de-
activate (by-pass) any sensors at their discretion. This
feature allows your home to be armed yet the person
inside the house can move freely in the area where the
sensor is by-passed.
Enter your PIN code and press ‘OK’ within 10 seconds.
Click on ‘Bypass’ on each sensor you want to bypass
After all the sensors to be by-passed have been
selected, press to return to user menu and the cursor
stays at ‘Arm’.
Press ‘OK’ to select ‘Arm’ to arm the system.
NOTE If a sensor is by-passed, then the Control Panel
will not respond to its triggering Arm mode
The by-pass setting is effective for only one time, once
the system is disarmed, the by-pass setting is cleared
automatically.
When a sensor is by-passed, the system can be armed
directly regardless of its fault situation (if any). However,
its fault situation is still being monitored and will be
logged and displayed when you access the ’Log’.
ALARM ACTIVATION
If a sensor is triggered when armed, or if an entry period
is left to expire, the control unit will activate the alarm
immediately, while if a home armed sensor is triggered,
the control unit will not respond if in home mode. If a 24-
hour alarm, fire alarm, personal attack, alarm tamper
or medical emergency is triggered, the control unit will
activate the alarm immediately irrespective of what armed
mode the control unit is in. During an alarm, the control
unit will sound the siren and contact the monitoring
Arm and disarm the system and practice using it. Trigger the alarm by
arming the system and opening protected doors/windows and walking past
PIR’s. Now is the time to show the rest of the family how simple it is to use.
8.0 USING THE SYSTEM
28
SMART ALARM USER GUIDE v1.1