User guide

station. If a tamper alarm is activated when the panel is
disarmed the system will dial out, and the siren will be on
but the alarm message will not be displayed.
STOPPING THE ALARM
A flashing ‘ALARM ’ will be displayed and the system will
sound an alarm.
DISARMING THE SYSTEM
Enter your pin code.
Press OK. The control unit will sound 2 short beeps
and disarm.
The siren will beep twice (If siren confirm has been
switched on) and the strobe will flash from side to side
after the system has been disarmed.
ALARM MEMORY
If an alarm was raised during your absence, and the alarm
sequence has been carried out, the screen will show
ALARM MESSAGES. To clear the messages, check each
alamr event.
LOW BATTERY DISPLAY
When a detector’s batteries are running low, it will signal
its condition to the control unit when it is activated. To be
able to clear the display the batteries in the detector will
have to be changed.
29
SMART ALARM USER GUIDE v1.1