User guide

PIR AND DOOR/WINDOW CONTACT
The LED will flash every time the device is activated
indicating a low battery and the control unit display
will identify the sensor low battery.
To prevent a tamper alarm, in the control unit select
‘Walk Test’.
Remove device from mounting.
Before changing the batteries check that the tamper
switch closes when mounted.
Change the batteries with alkaline Replacements.
Screw device back on.
KEYPAD REMOTE CONTROL
To indicate a low battery the ‘Active’ LED will flash
repeatedly. The control unit display will also indicate the
low battery condition.
To prevent a tamper alarm, in the control unit select
‘Walk Test’.
Remove keypad from mounting.
Before changing the battery check that the tamper
switch closes when mounted.
Change the battery with alkaline replacement. Screw
keypad back on.
SMOKE DETECTOR
The LED will flash to signal low battery.
Change the batteries as soon as possible with alkaline
replacements.
The control unit display will identify the smoke detector
low battery only after activation.
FLOOD DETECTOR
Remove the cover by loosening the fixing screws and
insert a new 12V battery
SIREN
The siren will produce a series of pips when armed and
disarmed, and an interrupted alarm sound (if activated) if
the siren batteries are near exhaustion.
Change the batteries as soon as possible. The sound
will be reset when the batteries are changed.
Before changing siren batteries, the siren tamper
must be disabled
When changing the batteries allow 1 minute
between taking out the old batteries and replacing
with the new.
WARNING After the batteries have been changed the
siren tamper will become active again. To avoid the siren
sounding in alarm, ensure that you follow the next step
before attempting to refit the siren cover.
34
SMART ALARM USER GUIDE v1.1