User guide
TO PROVIDE ADDITIONAL PROTECTION
you can add extra door/window contacts, PIRs, keyfob
remote controls, outdoor siren, CO detector, shock
sensor, gas detector, smoke detector, glass break
detector etc. Also, you can add various actuator devices
in order to manage your home lighting, heating, cooling,
shading... There is vast number of devices that can be
added to Zipato Smart Alarm to extend the system and
ensure even greater safety for you and your family. These
devices first must be connected to Zipabox. This is done
trough Join procedure that is basically the same for all
devices. Difference is in inclusion mode that is activated
by key or button press combination unique for each
device. This will be explained in next few paragraphs.
PREPROGRAMMED DEVICES
If your devices are already pre-programed you don’t have
to go through connection process because this devices
are preinstalled and will work once powered up.
10.1 ADDING NEW DEVICE
Before adding new device some preparation is needed
to ensure successful connection to Zipabox. First insert
batteries to device or connect it to the power supply.
It is recommended to bring device closer to Zipabox
so no obstacle can interfere with operating range of
device. Read device instruction regarding inclusion/
join mode. Device in inclusion/join mode is awake and
ready for joining in to Zipato network. In case that device
has already been used and connected to controller,
reset device. Reset deletes any information about prior
controller that was stored in device. At the end of joining
or removing session it is recommended to refresh Zipato
Control Center or wait until number of device isn’t
increased by one to make sure that device is visible in
Total device list.
10.2 KEYFOB
Z-Wave.Me Key Fob is small, portable devices that provide
convenient control of security and lighting functions, and
make arming and disarming simpler than ever. Key Fob is
the addition you’ve been missing, providing the simplest
control of devices, events or scenes, allowing you to not
only unlock doors, open garage doors or set the mood
when you get home - you can also choose to use this Key
Fob to control your existing array of Home Automation
devices, the way you want to. It is a fully functional
Z-Wave remote control capable of adding, removing and
controlling other Z-Wave devices.
FEATURES
4 user buttons
indication LED
Low battery indication
two way communication
Keyfobbe used in five different
modes that are picked by
configuration commands:
One of Zipato Smart Alarm great advantage is system
expandability. By adding additional accessories every corner
of your house can be covered and secured.
10.0 ACCESSORIES
35
SMART ALARM USER GUIDE v1.1