User guide

RESET KEYFOB
01. Before Key Chain Controller is added to Zipabox reset
it to delete any prior controller information.
02. Click on Add device button in General window
03. From drop down menu chose Generic Z-Wave
04. Click on Reset button
05. Follow on screen instruction:
06. “Add Key Chain Controller by pressing all four buttons
for five sec., then within ten sec. press button No.
3. When message appear “Device found” press all
four buttons and keep pressing until device join is
successful.”
07. If device reset was successful next message will
appear “Device reset successful” and Join device
button will appear. Clicking on it will proceed to Join
procedure
JOIN KEYFOB
01. Start Zipato Control Center. In the window General
click on Add device.
02. In following window from drop down menu chose
03. ZKeyfob and click Join button.
04. When discovery process starts press all four buttons
for five sec., then within ten sec. press button No.
3. When message appear “Device found” press all
four buttons and keep pressing until device join is
successful
05. If device is found two windows will appear with a
message, “device is found” and “Saving device”.
06. When message appear ”Device saved” click “Close”
07. Keyfob: it can be seen and configured trough Total
devices in General window and in Security widget under
Edit partitions options in Controls tab.
REMOVE KEYFOB
01. Start Zipato Control Center. Click on Remove device.
02. Click on Start button to start removal process
03. When removing process starts, press all four buttons
for five sec., then within ten sec. press button No. 3.
before countdown is over.
04. If device is removed successfully close window by
clicking on
button upper right corner.
10.3 RADIATOR VALVE
The temperature can be changed at any time using the
buttons on living connect. The change is transmitted
directly to the controller, which can synchronize the other
electronic radiator thermostats in the same room.
Radiator valve features an open-window function, which
closes the valve if the temperature in the room is falling
dramatically.
INSTALATION
Preparation:
Remove battery cover and insert two batteries.
Ensure that batteries are correctly inserted.
M must flash on the display before installation, if this
is not the case.
Fixing radiator valve on radiator installation
ADD RADIATOR VALVE TO ZIPABOX
Radiator valve is added to Zipabox trough Zipato Control
Center. This process is called inclusion or join.
36
SMART ALARM USER GUIDE v1.1