User guide

RESET RADIATOR VALVE
01. Click on Add device button in General window
02. From drop down menu chose Radiator valve
03. Click on Reset button
04. Follow on screen instruction
05. When countdown starts press discovery button
before it is over.
06. If device reset was successful next message will
appear “Device reset successful” and Join device
button will appear. Clicking on it will skip first 2 step
of join procedure
JOIN RADIATOR VALVE
01. Start Zipato Control Center. In the window General
click on Add device.
02. From drop down menu chose Radiator valve
03. When countdown starts press discovery button
before it is over on PIR motion detector before
countdown is over
04. If device is found the next two windows will appear
with a message, “device is found” and “Saving device”.
05. When message appear ”Device saved” click on “Close”
06. When radiator valve is connected to Zipabox it can be
seen in Zipato Control Center under Meters widget
REMOVE RADIATOR VALVE
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
03. When removing process starts, press Program Switch
button before countdown is over.
04. If device is removed successfully close window by
clicking on
button upper right corner.
REINSTALLATION MODE
If the thermostat has been removed from the radiator
and needs to be reinstalled (after being used), it is
necessary to activate installation mode to prevent
damage to the thermostat.
01. To enter installation mode:
02. Press
until is displayed.
03. Press
to withdraw the spindle, flashes.
Reinstall the thermostat on the valve. Press
for
approx. 3 seconds to exit.
After radator valve is added to Zipabox it can be
configured and used in Climate widget. To configure
radior valve go to General widget and click on Total
devices button. This will open new window where list of
all devices including radiator valve. Form here it can be
renamed. When Living connect is connected with zipabox
successfully it can be seen under Meters. Climate widget
is a graphical user-friendly interface for controlling room/
zone temperature and humidity. It can use all available
thermometers and hygrometers to achieve efficiency and
cost reduction while sustaining desired temperature and
humidity in one room or whole house.
In next few sections will be explained how to configure and
use radiator valve with climate widget.
CREATING NEW CLIMATE
Click on icon in upper right corner of Climate widget
to start new Climate. Window will appear with all device
endpoints that can be used for configuring climate.
In Name field write name of new climate.
01. For heating Outputs chose Danfos Living Connect
37
SMART ALARM USER GUIDE v1.1