User guide

HRT4-ZW back
Switch no. 1
ADD HRT4ZW TO ZIPABOX
HRT4-ZW is added to Zipabox trough
Zipato Control Center. These processes are called
inclusion or join.
RESET HRT4ZW
01. Click on Add device button in General window
02. From drop down menu chose HRT4-ZW
03. Click on Reset button
04. Follow on screen instruction
05. When countdown starts set switch 1 in ON position.
Turn the wheel until
is displayed, then press
wheel once.
06. If device reset was successful next message will
appear “Device reset successful” and Join device
button will appear. Clicking on it will skip first 2 step
of join procedure.
JOIN HRT4ZW
01. Start Zipato Control Center. In the window General
click on Add device.
02. From drop down menu chose HRT4-ZW
03. When countdown starts set switch 1 in ON position.
Turn the wheel until
is displayed, then press
wheel once.
04. If device is found the two windows will appear with a
message, “device is found” and “Saving device”.
05. When message appear ”Device saved” click on “Close”
06. When HRT4-ZW is connected to Zipabox it can be
seen in Zipato Control Center under Meters widget
Here can be seen that HRT4-ZXT shows two values.
First is set_point temperature and second is tempera-
ture in room. Switch between them by clicking on I or II.
NOTE When join procedure is over and HRT4-ZXT is
successfully added put switch no. 1 in On position for 3
sec then put it back in Off position.
REMOVE HRT4ZW
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
03. When countdown starts set switch 1 in ON position.
Turn the wheel until is displayed, then press wheel
once. If device is removed successfully close window
by clicking on
button upper right corner.
10.5 IR REPEATER ZXT120
The ZXT-120 is a Z-Wave to air-conditioner and it works
with any Z-Wave compliant gateway or portable controller
by translating Z-Wave’s Thermostat commands to AC
IR control code. It has built-in 5 direction IR emitters
(hemispherical coverage) User can set the IR code
from the built-in code library of ZXT-120 through the
configuration commands, or use the learning function
of ZXT-120 through the UI on gateway. ZXT-120 also has
built-in a temperature sensor that allow to report your
room temperature to home gateway. It can be utilized to
control or monitor your room temperature by your smart
phone or PC while you are at office, home anywhere or
around the world. ZXT-120 is a battery powered device
with battery life up to 18 months. It is convenient for end
user to place at anywhere around the air conditioner,
because there are 5 LED IR blasters built-in towards 5
directions. Alternative power source is USB adaptor.
39
SMART ALARM USER GUIDE v1.1