User guide

ZXT-120 is with built-in code library for most popular A/C
brands in the market. End user can select a particular
code number in the code list (refer to A/C code list) along
with the ZXT-120 through Z-wave standard Configuration
Command Class by gateway or controller. The pre-built-
in code library cannot 100% satisfy various user from
various region due to some unknown brands existing
in the market. So the Configuration Learning feature is
created as a backup solution when user cannot find any
correct code from the built-in code library.
TECHNICAL FEATURES:
fully complaint to Z-Wave command class
built-in AC IR code library
able to feedback the room temperature
build-in 5 direction IR emitters (hemispherical
coverage)
3.5mm jack for external wired IR emitter (optional)
transmit IR control code with a wide range of carrier
frequency (15-455kHz)
programmable power level (LOW or HIGH) for external
IR emitter to avoid saturation of IR receivers
Z-Wave-Frequency: 868.4MHz
Power Source: USB mini-B,5V DC Jack, or 3xAAA
batteries
dismountable battery box
dimension: Extender unit: 70mm (diameter) x 18mm
(thickness), Battery Box: 70mm (diameter) x 15.5mm
(thickness)
USAGE EXAMPLES:
Enables control of air-conditioning (AC) unit via the
Z-Wave network
Temperature sensor enables remote monitoring of
room temperature
Enables control of any device that uses IR remote
control ( TV, DVD player, Radio, etc..)
ADD ZXT120 TO ZIPABOX
ZXT-120 is added to Zipabox trough Zipato Control Center.
This process is called inclusion or join.
RESET ZXT120
01. Click on Add device button in General window
02. From drop down menu chose ZXT-120
03. Click on Reset button
04. Follow on screen instruction
05. When countdown starts press “PROG” button
06. If device reset was successful next message will
appear “Device reset successful” and Join device
button will appear. Clicking on it will skip first 2 step
of join procedure.
JOIN Z XT120
01. Start Zipato Control Center. In the window General
click on Add device.
02. From drop down menu chose ZXT-120
03. When countdown starts press “PROG” button
04. If device is found the two windows will appear with a
message, “device is found” and “Saving device”.
05. When message appear ”Device saved” click on “Close”
When ZXT-120 is connected to Zipabox it can be seen in
Zipato Control Center under Lights&Power Meters widget.
REMOVE ZX T120
01. Start Zipato Control Center. Click on Remove device
button.
02. Click on Start button to start removal process
40
SMART ALARM USER GUIDE v1.1