User guide

03. When countdown starts press “PROG” button.
04. If device is removed successfully close window by
clicking on
button upper right corner.
10.6 IR CODE LEARNING
User can follow the gateway UI to implement the learning
function, the learnt IR code will be stored in a specify
control key which contains the Mode, Temperature and
Fan Speed information.
Open Total devices window and find ZXT-120 if name
wasn’t changed by user. Click on Air conditioner IR and
chose Configuration menu. In there are 20 available slots
for learning IR commands.
To learn command prepare ZXT-120 and remote control
and place them as shown in picture below. And then
fallow next procedure.
01. Start learning mode in Zipato Control Center. LED on
ZXT-120 flashes once.
02. After LED flashes once, not before press and keep
holding the key on your original equipment remote
which you want to learn. Wait until LED flashes twice
and then OFF (learn code success). If LED flashes six
times rapidly and then OFF learns code fails. When
learn code fails start from step 1.
When you encounter problem, check followings:
Wait for LED indication and then press key on original
remote 1-2 sec after LED flashes once.
Do not release key on original remote before ZXT-120
return status during learning.
Press the key on original remote before learning mode
timeout. Keep away from incandescent light and direct
sunlight during learning.
Make sure IR Transmitter of your original remote
alight with learning diode of ZXT-120, you may also
slight adjust closer or further away the distance of two
devices. Some of remotes the IR transmitter in hidden
behind lens and may not installed center of remote.
Make sure the power is good on both devices,
especially the original remote. Use fresh batteries.
10.7 PLUG IN SWITCH MODULE WITH
POWER METER AN158
This plug-in ON/OFF Module is able to detect current
wattage (5~3150W) and overload wattage (3010~3300W)
of connected non-dimmable lights or appliances. When
detecting overload state, the Module will be disabled
and its On/Off button will be locked out of which LED
will flash quickly for 30 seconds. However, unplug and
re-connect the Module will reset its overload condition to
normal status.
energy saving device
user can turn on/off manually or remote
two way communication - can report status
keep track of power consumption
INCLUDE/EXCLUDE EVERSPRING AN158
Press On/Off button three times within 1.5 seconds.
41
SMART ALARM USER GUIDE v1.1