User guide

10.8 FLOOD SENSOR ST812
The ST812 is a battery-powered device, which is in sleeping
state unless an action is detected. After a programmable
sleeping time the device wakes up and sends a status in-
formation. After this the unit goes back to sleeping modus.
Batteries can be changed without unscrewing the device
from the door or frame. The unit will give a visual warning
on the device and sends a warning to the Z-Wave control-
ler, when batteries need to be replaced. Our Water/Flood
Sensors can help give you early warning about water leaks
or flood conditions. Responding to these conditions quickly
can help prevent expensive water damage. The sensor is
activated anytime the detector comes in contact with water.
FEATURES
Low battery indication
two way communication
battery operated for easy placement
long battery life with low battery notification
two way communication - can report status
APPLICATION
This sensor monitors leakage and sends an alarm when
flooding or leakage is detected. The sensing device can
be away up to 3 m from the main device. The unit can be
mounted on every flat surface. The installation can be
done with screws or double-sided tape.
INCLUDE OR EXCLUDE ST812
Pressing link key three times within 1.5 second will
enter inclusion mode. The detector will stay “awake” for
10 minutes to allow time for setting and device status
enquiring. In this mode device can be added or removed
from Zipabox.
01
Link key
01
10.9 SIREN SE812
The Siren SE812 Siren will warn everybody in the building
by a loud sound and a flashing light that an alarm has
occurred. This product is especially suited to use in
combination with other Z-Wave devices such as sensors.
The Siren gives a loud sound and a flashing warning light,
so everybody in the building will know immediately that
an alarm has occurred. You can choose to activate the
siren either by burglary alarm or by any other event in
your home. It is even possible to install multiple sirens,
so the alarm can be heard loudly at multiple locations.
FEATURES
Protocol: secure wireless 868.42 Mhz
Usage: indoor
Visible alarm, yes, red strobe light
Sound level: 90 and 100db selectable
Tamper alarm: yes
42
SMART ALARM USER GUIDE v1.1