User guide

AIRCONDITION IR:
Click on to open settings window.
NAME  change endpoint name
ROOM  switch position
TYPE  switch purpose
SUFIX  additional marker for switch
HIDDEN  hides switch from Lights&Power window
DESCRIPTION  short endpoint description
CONFIGURATION IR CODE LEARNING:
Used for IR code learning. Up to 20 key available.
To learn command prepare ZXT-120 and remote
control and place them as shown in picture below. And
then fallow next procedure.
First enter key name in empty field Start learning
mode by clicking on
button. LED on ZXT-120
flashes once.
After LED flashes once, not before press and keep
holding the key on your original equipment remote
which you want to learn. Wait until LED flashes twice
and then OFF (learn code success). If LED flashes six
times rapidly and then OFF learns code fails. When
learn code fails start from step 1.
Learnt code can be emitted by clicking on
button or key binding in Lights&Power window.
When you encounter problem, check followings:
Wait for LED indication and then press key on original
remote 1-2 sec after LED flashes once.
Do not release key on original remote before ZXT-120
return status during learning.
Press the key on original remote before learning mode
timeout. Keep away from incandescent light and direct
sunlight during learning.
Make sure IR Transmitter of your original remote
alight with learning diode of ZXT-120, you may also
slight adjust closer or further away the distance of two
devices. Some of remotes the IR transmitter in hidden
behind lens and may not installed center of remote.
Make sure the power is good on both devices,
especially the original remote. Use fresh batteries.
50
SMART ALARM USER GUIDE v1.1