Quick start Guide

ManualsBrandsZacuto ManualsDSLR Video Supports & RigsMarauder Foldable Camera Rig

INSTRUCTIONS

MARAUDER

YOUR CAMERA

HERE

PRESS

DOWN

PULL

PRESS

PULL UP TO

RE-POSITION

LEFT LOOSE

RIGHT TIGHT

NOTE A

NOTE B

LEFT LOOSE

RIGHT TIGHT

Loosen red lever

to change grip

position

TO UNFOLD GUNSTOCK PUSH DOWN ON SILVER BOLT WITH YOUR THUMB

WHILE PULLING UP ON THE BOTTOM OF THE GUNSTOCK ARM.

WITH THE GUNSTOCK ARM

LIFTED, ROTATE THE ARM 180

INTO THE OPEN POSITION AS

SHOWN.

NEXT PRESS THE LEVER AS SHOWN AND RAISE THE CAMERA SUPPORT ARM

INTO POSITION.

WITH YOUR CAMERA ATTACHED TO THE

GORILLA PLATE, ENGAGE 15MM ROD STUD

INTO THE BOTTOM OF THE BASEPLATE AND

SECURE BY TURNING THE RED LEVER.

FINALLY PRESS THE LEVER IN THE FRONT OF THE MARAUDER AND SWING

THE GRIP DOWN TWO CLICKS INTO THE MIDDLE POSITION OR WHERE

DESIRED (SEE NOTE A)

FIRST POSITION:

for use with cameras

equipped with a z-ﬁnder.

SECOND POSITION:

for use without a z-ﬁnder.

NOTE A: Grip: There are 4 different open positions for the grip that vary the distance from the

shooter’s body. Choose the one that is most comfortable for you and use the lever to articulate the

grip into a comfortable position.

NOTE B: Gunstock:

The gubstock can be pivoted so that it makes optimal contact with the shooter’s chest or shoulder.

Loosen the 2 screws to pivot the pad to the correct angle.

In some instances, depending on the type of camera used or the size of the shooter, the gunstock

pad will need to be ﬂipped into the up position for optimal comfort. To do this, unscrew the 2 10-32

allen screws completely, ﬂip the gunstock 180 and reattach the screws.

check out our tutorial videos

at zacuto.com

NEED

HELP?

Summary of content (1 pages)

PAGE 1
MARAUDER NEED MORE INSTRUCTIONS 1 TO UNFOLD GUNSTOCK PUSH DOWN ON SILVER BOLT WITH YOUR THUMB WHILE PULLING UP ON THE BOTTOM OF THE GUNSTOCK ARM. PRESS DOWN 2 HELP ? WITH THE GUNSTOCK ARM LIFTED, ROTATE THE ARM 180 INTO THE OPEN POSITION AS SHOWN. check out our tutorial videos at zacuto.com PULL UP 3 NEXT PRESS THE LEVER AS SHOWN AND RAISE THE CAMERA SUPPORT ARM INTO POSITION. 1ST 2ND FIRST POSITION: for use with cameras equipped with a z-ﬁnder. SECOND POSITION: for use without a z-ﬁnder.