User's Manual
Via C. Marx, 138 41012 Carpi (Mo)
Tel. +39 059 6232111
Fax. +39 059 6323298
User Manual
Rider Recognition System
P. I.V.A. 00172950362
File name: SPD009_21_r00.doc
Page 1 of 19
1.1
Key ON
The user recognizing with the active key (2) is performed as described below:
•
press the Lock/Unlock button (8) on the handlebar of the motorbike for less than 1 second;
•
the main unit (1) requires a radio frequency identification to the key (2 or 3) with an LF signal transmitted by the LF
antenna (5);
•
if the active key (2) is within a range of approx. 1.5 m and the battery is charged, replies to the main unit (1) by
transmitting its ID via an HF signal;
•
the main unit (1) receives the information through the HF antenna (6);
•
if the main unit (1) recognizes the active key (2): sets T15 ON, starts the transmission of a periodical message on CAN
bus and unlocks the motorbike steering by retracting the bolt (7).
Note:
when the battery is discharged, the active key (2) acts like a passive key (3), see the below.
The user recognizing with the passive key (3) is performed as described below:
•
press the Lock/Unlock button (8) on the handlebar of the motorbike;
•
the main unit (1) requires a radio frequency identification to the key (2 or 3) with an LF signal transmitted by the LF
antenna (5);
•
if the passive key (3) is within a range of approx. 5 cm near the LF antenna (5), replies to the main unit (1) by transmitting
its ID via an LF signal;
•
the main unit (1) receives the information through the LF antenna (5);
•
if the main unit (1) recognizes the passive key (3): sets T15 ON, starts the transmission of a periodical message on CAN
bus and unlocks the motorbike steering by retracting the bolt (7).
1.2
Key OFF
Key-Off occurs when motorcycle speed is equal to zero, by pressing button (6) on the handlebar. Neither active key (2) nor passive
key (3) are required.
1.3
Steering lock
To engage the steering lock:
•
Stop the motorcycle, then put it on the side stand and fully steer handlebar to the left or to the right;
•
press the Lock/Unlock button (8) and hold it depressed for more than 2 second with steering turned completely to the left
or to the right: steering lock will be engaged after this time (the bolt of the system (7) goes out).
Note:
In case of failed engagement of steering lock, the signal LED will blink 4 times.