User's Guide

6
1 2
Pressing Power button
again will turn the
Machine OFF.
1 2
1 2
Replace plastic cover
on Cutting Mat when
not in use.
Only use fabric on Coral
color fabric Cutting Mat.
SET UP
DO NOT unplug USB cable from computer while Machine is in use.
This will cause loss of data.
NOTICE
WARNING: MOVING PARTS Keep fingers, hair and clothing away.
3
Activate loading using
eCAL software on your
Computer.
STARTING THE MACHINE
CUTTING MATS
LOADING THE CUTTING MAT INTO THE MACHINE
Rollers
Guides
12" – 24"
12"
WORKSPACE
PLACEMENT
Leave 12 to 24 inches of clear space behind your eclips
®
2 Machine to allow full
Cutting Mat movement.
Place your eclips2 Machine at least 12 inches from the edge of your work surface
to prevent it from tipping over and causing possible injury.
ENVIRONMENT
Place eclips2 Machine on a clean, level, dry and sturdy surface.
PLACING MATERIAL
ON THE CUTTING MAT
Peel back and remove plastic cover
from Cutting Mat.
Align material to be cut with top-left
edge of Cutting Mat. Press evenly
into place.
Open cover (Cutting Mat can also
be loaded with Machine cover
closed.)
When removing more intricate
shapes from Cutting Mat, an eclips
Die Pick or Scraper is recommended.
Plug Power Cord into wall outlet. Plug
the other end into your eclips2 Machine.
Press Power button (front of Machine shown).
Unplug Machine when not in use.
Place Cutting Mat between Alignment
Guides and insert into Machine until the
leading edge touches the Rollers.