User's Guide

CUTTING BLADE MAINTENANCE

CLEANING THE CUTTING BLADE

MAINTENANCE

Loosen Blade Holder Clamp

by turning Clamp Screw

counterclockwise. Remove

Blade Holder.

Push down on Blade Ejection Pin

to reveal Blade. Carefully remove

and discard used Blade.

Carefully insert new Blade into

hole at bottom of Blade Holder;

Blade is held in place magnetically.

Replace Blade Holder in Machine,

as shown on page 5.

2 3

Blade Ejection Pin

Blade

CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.

WARNING: CHOKING HAZARD Small parts. Keep away from children.

CAUTION: CUTTING HAZARD Blade is sharp, handle with care.

CAUTION: Always unplug Machine before removing or installing Blade Holder.

Non-Cutting Side

ADJUSTING THE CUTTING BLADE DEPTH

REPLACING THE CUTTING BLADE

Lift open Machine Cover to

expose Carriage and Blade

Holder Clamp.

Clamp Screw

After prolonged use, the Cutting Blade may not cut as precisely as it once did. To help prolong the life of the Cutting

Blade, remove it from the Blade Holder and clean it with Isopropyl Alcohol (rubbing alcohol) poured onto a clean

paper towel. Remove any material left inside the Cutting Blade Holder, using a Die Pick Tool.

Visit sizzix.com to see a complete selection of available accessories.

Printed on a ring around the Blade Holder Top are Blade Depth Settings, ranging from 1 to 6. These numbers can be

selected individually by turning the wheel to the number relative to the material you are using. Refer to page 4 for

more information about setting the Blade Depth.