Zalman Tech Co., Ltd. User’ s Manual CNPS5100-Al CNPS5100-AlCu CNPS5100-Cu http://www.zalman.co.kr E-mail:zalman@zalman.co.
CNPS5100-Al, CNPS5100-AlCu, CNPS5100-Cu The CNPS5100-Al / CNPS5100-AlCu / CNPS5100-Cu coolers come with an adjustable fan speed connector (FAN MATE 1) for allowing you to vary the CPU fan speed to create an optimal cooling environment. 1. Features 1) Zalman’s CPU Coolers do not generate noise and vibration in silent mode. 2) The heat dissipating material of the Flower HeatSink (FHS) is pure copper or aluminum. 3) Innovative FHS(Flower HeatSink) design offers lower noise and thermal resistance.
) FAN MATE 1 ① Dimensions : 200(L) X 23(W) X 21(H) mm ③ Output Voltage : 5V ~ 11V ± 2% ② Weight : 20 g ④ Allowable Wattage : 6W or lower 4. Compatibility of CPU : Socket 462 - AMD Duron, AMD Athlon, AMD Athlon XP Socket 423 - INTEL Pentium 4 CPU Type Silent Model Silent Model Duron Athlon Up to 1.6㎓ CNPS5100-Al CNPS5100-AlCu Normal Model Up to 2.0㎓ CNPS5100-Cu AMD INTEL Pentium 4 Model Up to 1.7㎓ Support all current CPU Clock speed Athlon XP Athlon XP (T-Bird) Up to 1.67㎓ Up to 2.
Installation of FHS 1. First, check whether your CPU is a P4 CPU or an AMD CPU. Then, depending on the type of CPU, insert the bolts (A or B) into the appropriate holes in the cooler body (See Figure 1). Intel P4 CPU AMD CPU < Figure 1 > 2. Check whether or not nipples (spacers) for installing a CPU cooler are mounted between the mainboard and the computer case.
(3) Check the locations of the holes around the socket and those of the bolts A mounted in the mounting holes, and then place the FHS horizontally on the center of the CPU. Mainboard (4) To make the FHS completely contact the CPU core (this is important to protect the CPU core from overheating), tighten each bolt A by one turn in the order shown in Figure 2 (i.e., in a diagonal sequence) with a screw driver until they no longer go in (as shown in Figure 4).
(2) Insert one of the provided bolts B into a tapered spring as shown in Figure 5, and insert the bolt B into an appropriate mounting hole of the cooler body (See Figure 1). Repeat until four bolts are installed in the cooler body. (Caution! The diameter of the spring increases from one end to the other end. The end of the spring having Good a smaller diameter should be directed to the head of Bad < Figure 7 > the bolt as shown in Figure 7.
Adjusting Fan Speed 1. Connect FAN MATE 1 (adjustable fan speed connector) to the 3-pin connector of a fan as shown in Figure 10. 2. Connect FAN MATE 1 to the 3-pin CPU fan connector of the mainboard. 3. Turn on the computer after assembly is finished. 4. When booting a computer in which FAN Mate 1 is used, an alarm sound may be generated by a system monitoring program to indicate that the rotation of the CPU fan is slow.
