Cautions on Use and Installation 1. By installing this product on a VGA (Video Graphics Array) card, two PCI slots adjacent to the PCIe (or AGP) slot occupied by the VF2000 will become unusable. 2. The product CANNOT be installed on Matrox VGA cards, NVIDIA PCX 5*** , NVIDIA Geforce 6600 AGP Series, Geforce 7600/7900 AGP Series, and ATI Radeon 9550/9600 Series, any cards with less than four installation holes, and any cards with a diagonal installation hole distance that is not 75.2mm. 3.
Explode View (Usage as VGA Cooler) 2
Explode View (Usage as CPU Cooler) Intel 775 Intel Socket Socket 775 AMD Socket AM2/AM2+ 3
Installation Procedure (Usage as VGA Cooler) ※ The following installation sequence MUST be followed. (1. VGA RAM Heatsink Attachment → 2. Thermal Grease Application → 3. Nipple A Installation on Retention Guide → 4. Spring Insertion on the Fixing Nut → 5. VGA Cooler Installation → 6. VGA Card Installation → 7. Fan Power Cable Connection) 1. VGA RAM Heatsink Attachment Remove the film from the Thermal Tapes on the bottom of the RAM Heatsinks and attach the Heatsinks on the VGA RAM.
5. VGA Cooler Installation 1) Insert the Rubber Rings A into the VGA Cooler’s Nipples A. 2) Install the Nipple A-attached VGA Cooler on the VGA card’s mounting holes. ※ The VGA Chipset MUST be positioned on the center of the VGA Cooler’s base. 3) Simultaneously hold the VGA Cooler and the VGA card with one hand, then flip the VGA card so that its backside is facing upwards.
Installation Procedure (Usage as CPU Cooler) ※ The following installation sequence MUST be followed. (1. Removal of Motherboard from Case → 2. Removal of pre-installed coolers and installation hardware → 3. Thermal Grease Application → 4. Installation of Intel/AMD Clip → 5. Installation of Nipple B onto Clip → 6. Spring Insertion on the Fixing Nut → 7. VF2000 installation → 8. Motherboard Installation → 9. Fan Power Cable Connection) 1.
5. Installation of Nipple B Install the short end of Nipple B onto the Clip that was previously Installed onto the VF2000. (Note) The Nipples MUST be tightened by hand. Using tools to tighten the Nipples may damage the tips of the Nipples .Please take extra precaution when fastening the Nipples. 6. Spring Insertion on the Fixing Nut Slowly turn the Spring in counter clockwise motion so that the Spring is correctly attached to the Fixing Nut. Note 1) The ends of the Springs are of different diameters.
8. Motherboard Installation Install the motherboard (with the VF2000 installed) into the case. After the motherboard is installed, please check for interferences with the components such as the PSU, ODD etc.. 9. Fan Power Cable Connection Please refer to “7. Fan Power Cable Connection” on page 5.
