(English Version) ZM-WB4 Gold CPU WATER BLOCK for Higher Water Cooling Performance Please visit our website and watch the ZM-WB4 Gold installation video for easy installation. ※ Please read this manual thoroughly before installation. ※ The specifications of this product and its components may change without prior notice to improve performance. http://www.zalman.co.kr http://www.zalmanusa.
Precautions 1) Test the product for leakage away from the system before installing it on the system. confirming no leakage, proceed with the installation and use. 2) Use approved coolant for computer water-cooling to prevent corrosion. 3) Use coolant tubes listed under the compatibility list. 4) Do not use the product if it interferes with any motherboard components. 5) Familiarize yourself with this manual. 6) Keep this product and its associated system away from children. Disclaimer Zalman Tech Co., Ltd.
. Exploded View Bolt Clip Bolt Clip for Intel Water Block Assembly Fixing Bolt for Clip Support Clip Support for Socket 775 Clip Support for Socket 478 Backplate for Socket 775 Retention Guide Intel Pentium 4 (Socket 775) Intel Pentium 4 (Socket 478) ※ Clip Combinations for Intel Clip for AMD ZM-WB4 Gold Retention Guide for AMD AMD (Socket AM2/754/939/940) ※ Installation for Different Tube Size Tube Clamp B (11.5 X 8mm):13x9mm, 12x9mm, 12x8mm, 11x8mm, 10x8mm Tube Clamp A (13.
. Components 1) Common Components ① CPU Water Block Assembly ② Two(2) Clips ③ Four(3) Bolts ④ Three(3) Clip Bolts ⑤ Thermal Grease ⑥ Two(2) Tube Clamps A (13.8 X 8mm ) ⑦ Two(2) Tube Clamps B (11.
. Installation 1) Intel Pentium 4 -775 ① Install Clip Supports for Socket 775 Align the clip support for socket 775 and the backplate for socket 775 with the mounting holes on the motherboard and fasten them together using the clip support fixing bolt. The lever slot on the clip support should be properly oriented on the hinged side of the socket lever when installing.
Note 1) Make sure that the outlet is installed in a manner so that the outlet is placed above the inlet as shown in the picture. Outlet Inlet Motherboard 2) Intel Pentium 4 -478 ① Install the Clip Supports for Socket 478 Install the Clip Supports for Socket 478 on both sides of the Retention Guide as shown in the diagram on the right. ② Install Clip Align the Clips’ holes with the Waterblock tabs as shown in the diagram, and install the Clips by slowly screwing the Clip Bolts into the Clip holes.
③ Apply Thermal Grease Clean the contact surface of the CPU completely. Apply Thermal Grease on the CPU surface that makes contact with the base of the Water Block. Thermal Grease ④ Install CPU Water Block Set the CPU Water Block at the center of the CPU. Screw the Bolts in slightly, then tighten each Bolt a few turns at a time while alternating between the two until the Clips are completely pressed against the Clip Support.
Zalman Noise Prevention System Stable performance and noiseless liquid cooling system can both be achieved with the use of Zalman’s Noiseless Power Supply, Heatpipe Hard Disk Cooler, Noiseless Case Fan and Northbridge Water Block.
