User Guide

www.zalman.co.kr www.zalmanusa.com
9
Tighten Nut A on the Nipple that now has the Plate Spring in place.
6.9. Installing the Backside Heatsink Base Assembly
1) Viewing from the side, make sure that both Heatsink Base Assemblies are parallel with the VGA card, and that their edges are
parallel to each other.
(If the Heatsink Base Assemblies are not aligned properly, the heatsinks cannot be installed properly.)
2) Tighten each Bolt A and Bolt C completely.
6.10 Confirming Proper Installation of the Two Heatsink Base Assemblies (VERY IMPORTANT)
Evenly apply the Thermal Grease in the grooves of the Frontside Heatsink Base as shown in the diagram.
6.11 Applying Thermal Grease on the Frontside Heatsink Base
Nut A
Nut A
Nipple
Nipple
Rubber Ring
Nut
B
Bolt C
Bolt A
Bolt A
Bolt C
Backside Heatsink Base
Frontside Heatsink Base
Front
Back
Front
Back
Frontside
Heatsink Base
Thermal
Grease
Thermal Grease
Apply Thermal
Grease here
Thick
Paper