EN User Manual Dishwasher KDT10003FB
Contents Safety information Safety instructions Control panel Programmes Settings Before first use 2 3 4 5 5 7 Daily use Hints and tips Care and cleaning Troubleshooting Technical information 8 9 11 12 14 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
• • • • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down. Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it.
• • The appliance can release hot steam if you open the door while a programme operates. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Service • Warning! Dangerous voltage. • • If the water inlet hose is damaged, immediately close the water tap and disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. Use • • • • Contact the Authorised Service Centre to repair the appliance.
Programmes Programme 2) 3) 4) Degree of soil Type of load Programme phases Consumption values 1) Duration (min) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Pre-wash Wash 50 °C Rinses Dry 227 1.039 11 Heavy soil Crockery, cutlery, pots and pans • • • • Pre-wash Wash 70 °C Rinses Dry 155 - 170 1.5 - 1.7 14-15 Normal soil Crockery and cutlery • • • • Pre-wash Wash 65 °C Rinses Dry 130 - 140 1.4 - 1.6 15-17 Fresh soil Crockery and cutlery • 30 0.
RESET function Press the programme button until the appliance is in programme selection mode. With this function you can cancel the running programme. User mode While the appliance is in programme selection mode: 1. Press and hold the programme button until the indicator flashes, and the indicators and are on. Settings available in the user mode: • The level of the water softener according to the water hardness. • The activation or the deactivation of the acoustic signal for the end of programme.
While the appliance is in user mode, within about 5 seconds: 1. Press the programme button. • The indicators and • The indicator flashes. are on. 2. Wait until the indicators 3. • The indicator is off = the acoustic signal is deactivated. Press the programme button to change the setting. 4. • The indicator is on = the acoustic signal is activated. Press the on/off button to confirm the setting. and are off. Activating AirDry AirDry improves the drying results with less energy consumption.
Adding salt Before the first use, put one litre of water in the salt container. Caution! Water and salt can come out of the salt container during filling. To prevent corrosion, start a programme immediately after filling the salt container. Adding rinse aid 1 43 21 A 2 The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse phase. Fill the rinse aid dispenser when the lens (A) is clear. Daily use 1. Open the water tap. 2.
Adding multi-tablets 1 30 20 2 • • Do not fill the salt container and the rinse aid dispenser. Set the rinse aid dispenser to the lowest position. Setting and starting a programme Starting a programme 1. 2. 3. 4. Keep the appliance door ajar. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. Press the programme button until the indicator of the chosen programme is flashing. Close the appliance door to start the programme.
• • You can use dishwasher detergent, rinse aid and salt separately or you can use the multi-tablets (e.g. ''3in1'', ''4in1'', ''All in 1''). Follow the instructions written on the packaging. Select the programme according to the type of load and degree of soil. With the ECO programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil.
Care and cleaning Warning! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. Cleaning the filters B A C • • • • Make sure that there are no residues of food or soil in or around the edge of the sump. Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides. Reassemble the filters (A) and (B).
Troubleshooting If the appliance does not start or it stops during operation, before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems the end indicator flashes intermittently indicating a malfunction. The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. Warning! Repairs not properly done may result in serious risk to the safety of the user.
Problem and alarm code Possible cause and solution • The appliance trips the circuit-beaker. • The amperage is insufficient to supply simultaneously all the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use. Internal electrical fault of the appliance. Contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre.
Problem Possible cause and solution Unusual foam during washing. • • Use the detergent for dishwashers only. There is a leak in the rinse aid dispenser. Contact an Authorised Service Centre. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener". Silver and stainless steel cutlery were placed together. Avoid to put silver and stainless steel items close together. • There are residues of detergent in the dispenser at the end of the programme.
Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. Rating Plate Information for test institutes For all the necessary information for test performance, send an email to: info.test@dishwasher-production.com Mod. ... ... ... Prod. No. ... ... ... Ser. No. ...
www.electrolux.