User manual

Caution! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
If, afterwards, the door is closed for
another 3 minutes, the running
programme ends.
AirDry is automatically activated with all programmes
excluding (if applicable).
To improve the drying performance refer to the XtraDry
option or activate AirDry.
Caution! If children have access to the
appliance, it is advised to deactivate
AirDry as opening the door may pose a
danger.
How to deactivate AirDry
Make sure the appliance is in user mode.
1. Press .
• The indicators , , and are
off.
• The indicator still flashes.
• The indicator shows the current setting.
– If the indicator is on = AirDry is
activated.
– If the indicator
is off = AirDry is
deactivated.
2. Press to change the setting.
3. Press on/off to confirm and save the setting.
Options
Desired options must be activated every
time before you start a programme.
It is not possible to activate or deactivate
options while a programme is running.
Not all options are compatible with each
other. If you select non compatible
options, the appliance automatically
deactivates one or more of them. Only
the indicators of the still active options
are on.
XtraDry
Activate this option to boost the drying performance.
With XtraDry on, the duration of some programmes,
water consumption and the last rinse temperature can
be affected.
XtraDry is a permanent option for all programmes other
than and need not to be selected at every
cycle.
In the other programmes the setting of XtraDry is
permanent and it is automatically used in next cycles.
This configuration can be changed at any time.
Every time is activated, XtraDry
is off and needs to be chosen manually.
How to activate XtraDry
Press simultaneously and . The indicator is
on.
If the option is not applicable to the programme, the
related indicator is off or it flashes quickly for a few
seconds and then goes off.
Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
After starting a programme, it may take up to 5 minutes
for the appliance to recharge the resin in the water
softener. It seems that the appliance is not working. The
washing phase starts only after this procedure is
completed. The procedure is repeated periodically.
The salt container
Caution! Use rough salt designed for
dishwashers only. Fine salt increases the
risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in daily
use.
9