User manual

• Make sure that there are no residues of food or soil in or around the edge of the sump.

• Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides.

• Reassemble the filters (A) and (B).

• Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.

An incorrect position of the filters can cause bad washing results and damage to the appliance

Cleaning the spray arms

Do not remove the spray arms. If the holes in the spray

arms are clogged, remove remaining parts of soil with a

thin pointed object.

External cleaning

• Clean the appliance with a moist soft cloth.

• Only use neutral detergents.

• Do not use abrasive products, abrasive cleaning

pads or solvents.

Internal cleaning

• Carefully clean the appliance, including the rubber

gasket of the door, with a soft moist cloth.

• If you regularly use short duration programmes,

these can leave deposits of grease and limescale

inside the appliance. To prevent this, we

recommend to run long duration programmes at

least 2 times per month.

Troubleshooting

If the appliance does not start or it stops during

operation, before you contact an Authorised Service

Centre, check if you can solve the problem by yourself

with the help of the information in the table.

With some problems the end indicator flashes

intermittently indicating a malfunction.

Problem and alarm code Possible solution

You cannot activate the appliance.

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that there is no a damage fuse in the fuse box.

The programme does not start.

• Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the end

of the countdown.

• The appliance has started the procedure to recharge the res-

in inside the water softener. The duration of the procedure is

approximately 5 minutes.