User manual

• The current setting is indicated by the number of flashes of the indicator (e.g. 5 flashes + pause + 5
flashes = level 5).
2. Press to change the setting. Each time you press , the level increases. After level 10 you will
start again from level by 1.
3. Press the on/off button to confirm the setting.
The water hardness table
German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke degrees Water softener lev-
el
47 -50 84 - 90 8.4 - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1
2)
1) Factory setting
2) Do not use salt at this level.
Activating the acoustic signal for the end of programme
While the appliance is in user mode:
1. Press the indicator starts to flash.
• The indicators and go off.
• The end indicator indicates the current setting: End indicator off = Acoustic signal off.
2. Press
to change the setting.
• End indicator on = Acoustic signal on.
3. Press on/off button to confirm the setting.
7