User manual

Deactivating the rinse aid dispenser
While the appliance is in user mode:
1. Press
.
• The indicators and goes off.
• The indicator starts to flash.
• The end indicator indicates the current setting: End indicator on = rinse aid dispenser activated.
2. Press
to change the setting. End indicator off = rinse aid dispenser deactivated.
3. Press the on/off button to confirm the setting.
Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
When you start a programme, the appliance can take up
to 5 minutes to recharge the resin in the water softener.
It seems that the appliance is not working. The washing
phase starts only after this procedure is completed. The
procedure will be repeated periodically.
The salt container
Caution! Only use salt specifically
designed for dishwashers.
The salt is used to recharge the resin in the water
softener and to assure good washing results in the daily
use.
Adding salt
Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
8