EN User Manual Hob KEV6530RXK
Contents Safety information Safety instructions Installation Product description Daily use 2 3 5 6 8 Hints and tips Care and cleaning Troubleshooting Technical data Energy efficiency 10 11 11 13 13 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
• • • • • • • • • WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. WARNING: Danger of fire: Do not store items on the cooking surfaces.
Electrical Connection Warning! Risk of fire and electric shock. • • • • • • • • • • • • • • • • • • • • • All electrical connections should be made by a qualified electrician. The appliance must be earthed. Before carrying out any operation make sure that the appliance is disconnected from the power supply. Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. Make sure the appliance is installed correctly.
• • • Disconnect the appliance from the electrical supply before maintenance. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use any abrasive products, abrasive cleaning pads, solvents or metal objects. To repair the appliance contact an Authorised Service Centre. Use original spare parts only. Disposal Warning! Risk of injury or suffocation.
Protection box If you use a protection box (an additional accessory), the protective floor directly below the hob is not necessary. The protection box accessory may not be available in some countries. Please contact your local supplier. You can not use the protection box if you install the hob above an oven.
Sensor field Function Comment 1 ON / OFF To activate and deactivate the hob. 2 Lock / Child Safety Device To lock / unlock the control panel. 3 Pause To activate and deactivate the function. 4 - Heat setting display To show the heat setting. 5 - Timer indicators of cooking zones To show for which zone you set the time. 6 - Timer display To show the time in minutes. 7 - To activate and deactivate the outer ring. 8 - To select the cooking zone.
OptiHeat Control (3 step Residual heat indicator) Warning! / / There is a risk of burns from residual heat. The indicators show the level of the residual heat for the cooking zones you are currently using. The indicators may also come on for the neighbouring cooking zones even if you are not using them. Daily use Warning! Refer to Safety chapters. Activating and deactivating Touch hob.
To set the cooking zone: touch again and again until the indicator of a necessary cooking zone comes on. To activate the function: touch of the timer to set the time (00 - 99 minutes). When the indicator of the cooking zone starts to flash slowly the time counts down. To see the remaining time: set the cooking zone with . The indicator of the cooking zone starts to flash quickly. The display shows the remaining time. To change the time: set the cooking zone with Touch or . .
OffSound Control (Deactivating and activating the sounds) To confirm your selection wait until the hob deactivates automatically. Deactivate the hob. Touch When the function is set to only when: for 3 seconds. The display comes on and goes out. Touch seconds. or comes on.
Care and cleaning Warning! Refer to Safety chapters. • General information • • • • • Clean the hob after each use. Always use cookware with a clean base. Scratches or dark stains on the surface have no effect on how the hob operates. Use a special cleaner suitable for the surface of the hob. Use a special scraper for the glass. • cause damage to the hob. Take care to avoid burns. Use a special hob scraper on the glass surface at an acute angle and move the blade on the surface.
Problem The hob deactivates. Possible cause You put something on the sensor field . Remedy Remove the object from the sensor field. Residual heat indicator does not come on. The zone is not hot because it operated only for a short time or the sensor is damaged. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre. Automatic Heat Up does not operate. The zone is hot. Let the zone become sufficiently cool. The highest heat setting is set.
Technical data Rating plate Model KEV6530RXK Typ 60 HAD 20 AO PNC 949 594 443 01 220 - 240 V 50 - 60 Hz Made in Germany 5.7 kW Ser.Nr. ................. ZANKER Cooking zones specification Cooking zone Nominal Power (Max heat setting) [W] Cooking zone diameter [mm] Left front 1800 180 Left rear 1200 145 Right rear 1700 / 2700 210 / 270 For optimal cooking results use cookware no larger than the diameter of the cooking zone.
• Use the residual heat to keep the food warm or to melt it. Environmental concerns dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
www.electrolux.