Benutzerinformation Kühlschrank KRG15802WE
Inhalt Sicherheitshinweise _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Betrieb _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Erste Inbetriebnahme _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Täglicher Gebrauch _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Praktische Tipps und Hinweise _ _ _ _ _ _ _ _ _ _ _ 2 4 4 5 5 Reinigung und Pflege _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Was tun, wenn … _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Technische Daten _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Montage _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Umweltt
• Technische und anderweitige Änderungen am Gerät sind gefährlich. Ein defektes Netzkabel kann Kurzschlüsse und einen Brand verursachen und/oder zu Stromschlägen führen. Warnung! Elektrische Bauteile (Netzkabel, Stecker, Kompressor) dürfen zur Vermeidung von Gefahren nur vom Kundendienst oder einer Fachkraft ausgewechselt werden. 1. 2. Das Netzkabel darf nicht verlängert werden. Vergewissern Sie sich, dass der Netzstecker nicht von der Geräterückseite gequetscht oder beschädigt wird.
pressor, Kondensator) möglichst mit der Rückseite gegen eine Wand aufgestellt werden. • Das Gerät darf nicht in der Nähe von Heizkörpern oder Kochern installiert werden. • Vergewissern Sie sich, dass der Netzstecker des Gerätes nach der Installation frei zugänglich ist. • Wenn ein Wasseranschluss vorgesehen ist, verbinden Sie das Gerät nur mit einem Trinkwasseranschluss.
Wichtig! Verwenden Sie keine Reinigungsmittel oder Scheuerpulver, da hierdurch die Oberfläche beschädigt wird. Täglicher Gebrauch Einfrieren frischer Lebensmittel Das Gefrierfach eignet sich zum Einfrieren von frischen Lebensmitteln und zum Lagern von gefrorenen und tiefgefrorenen Lebensmitteln für einen längeren Zeitraum. Für das Einfrieren frischer Lebensmittel ist eine Änderung der mittleren Einstellung nicht erforderlich.
• Beim Ein- oder Ausschalten des Kompressors ist ein leises "Klicken" des Temperaturreglers zu hören. Das ist normal. Energiespartipps • Öffnen Sie die Tür nicht zu häufig, und lassen Sie diese nicht länger offen als unbedingt notwendig. • Wenn die Umgebungstemperatur hoch ist und der Temperaturregler auf eine niedrige Temperatur eingestellt und das Gerät voll beladen ist, kann es zu andauerndem Betrieb des Kompressors und damit zu Reif- oder Eisbildung am Verdampfer kommen.
• Das Haltbarkeitsdatum auf der Tiefkühlkostverpackung sollte nicht überschritten werden. Reinigung und Pflege Vorsicht! Ziehen Sie bitte vor jeder Reinigungsarbeit immer den Netzstecker aus der Steckdose. Der Kältekreis des Gerätes enthält Kohlenwasserstoffe; Wartungsarbeiten und Nachfüllen von Kältemittel dürfen daher nur durch vom Hersteller autorisiertes Fachpersonal ausgeführt werden.
erreichen, und lassen Sie das Gerät zwei bis drei Stunden mit dieser Einstellung laufen. Legen Sie die ausgelagerten Lebensmittel wieder in das Fach hinein. 1. 2. 3. Wichtig! Verwenden Sie bitte niemals scharfe Gegenstände zum Entfernen von Reif und Eis vom Verdampfer, da dieser dadurch beschädigt werden könnte. Benutzen Sie keine mechanischen oder sonstigen Hilfsmittel, um den Abtauprozess zu beschleunigen; halten Sie sich dazu ausschließlich an die Angaben des Geräteherstellers.
Störung Mögliche Ursache Abhilfe Die Tür ist nicht richtig geschlossen. Siehe hierzu "Schließen der Tür". Die Tür wurde zu häufig geöffnet. Lassen Sie die Tür nicht länger als unbedingt erforderlich offen. Die Temperatur der zu kühlenden Lebensmittel ist zu hoch. Lassen Sie die Lebensmittel auf Raumtemperatur abkühlen, bevor Sie sie in das Gerät legen. Die Raumtemperatur ist zu hoch. Senken Sie die Raumtemperatur. Wasser fließt an der Rückwand des Kühlschranks hinunter.
Lampe wechseln Vorsicht! Trennen Sie den Netzstecker von der Netzversorgung. 1. 2. 3. Lösen Sie die Schraube an der Lampenabdeckung. Nehmen Sie die Lampenabdeckung ab (siehe hierzu die Abbildung). Ersetzen Sie die alte Lampe durch eine Lampe der gleichen Leistung (die maximal erlaubte Leis- tung steht auf der Lampenabdeckung), die speziell für Haushaltsgeräte vorgesehen ist. Bringen Sie die Lampenabdeckung an. Ziehen Sie die Schraube an der Lampenabdeckung fest.
Ausrichten Bei der Aufstellung des Gerätes ist dieses waagerecht auszurichten. Dies lässt sich mit zwei Schraubfüßen (2) am vorderen Sockel des Gerätes erreichen. Bei Bedarf kann zum Einstellen der Schraubfüße das Distanzstück (1) entfernt werden. 1 2 Standort 15 mm 15 mm min.100 mm Das Gerät sollte möglichst weit entfernt von WärmeWarnung! quellen wie Heizungen, Boilern oder direktem Sonnenlicht usw. aufgestellt werden. Die Luft muss frei auf der Geräterückseite zirkulieren können.
Montage unter einer durchgängigen Arbeitsplatte Wird der Kühlschrank unter einer durchgängigen Arbeitsplatte installiert, ist hinten an der Arbeitsplatte eine Luftauslassöffnung von mindestens 200 cm2 anzubringen und ein zum Arbeitsplattendesign passendes Lüftungsgitter zu installieren. Die Schnittflächen an der Arbeitsplatte sind zu lackieren, damit sie nicht durch eindringende Feuchtigkeit aufquellen.
Einsetzen und Befestigen an der durchgängigen Arbeitsplatte Wechseln Sie ggf. vor dem Einsetzen den Türanschlag (siehe: Wechseln des Türanschlags). Schieben Sie das Gerät vorsichtig in die Einbaunische. Achten Sie darauf, dass das Netzkabel nicht eingeklemmt wird. Kontrollieren Sie den Abstand zur Wand (siehe: Montage unter einer durchgängigen Arbeitsplatte). Zum Ausrichten des Geräts die beiden Schraubfüße auf der Vorderseite heraus- oder hineinschrauben, um einen stabilen Stand zu erreichen.
1. Ziehen Sie den Stecker aus der Steckdose. 2. Neigen Sie das Gerät vorsichtig nach hinten, so dass der Kompressor den Boden nicht berühren kann. 3. Schrauben Sie beide Schraubfüße ab. 4. Lösen Sie die Schrauben des unteren Türscharniers. Nehmen Sie das Scharnier ab. Stecken Sie es in Pfeilrichtung auf den Stift. 5. Lösen Sie die Schraube und bringen Sie sie an der gegenüberliegenden Seite wieder an. 6. Befestigen Sie das Scharnier an der gegenüberliegenden Seite. 8.
Wechsel des Gefrierfach-Türanschlags 180˚ Steckdose Vorsicht! Achten Sie darauf, dass sich das Netzkabel des Geräts frei bewegen lässt. Die zum Anschluss des Geräts an die Stromversorgung erforderliche Steckdose muss so angeordnet sein, dass der Gerätestecker aus der Steckdose gezogen werden kann. Wird das Gerät unter einer durchgängigen Arbeitsplatte installiert, ist die Steckdose wie abgebildet anzuordnen.
Umwelttipps Das Symbol auf dem Produkt oder seiner Verpackung weist darauf hin, dass dieses Produkt nicht als normaler Haushaltsabfall zu behandeln ist, sondern an einem Sammelpunkt für das Recycling von elektrischen und elektronischen Geräten abgegeben werden muss. Durch Ihren Beitrag zum korrekten 16 Entsorgen dieses Produkts schützen Sie die Umwelt und die Gesundheit Ihrer Mitmenschen. Umwelt und Gesundheit werden durch falsches Entsorgen gefährdet.
www.electrolux.