User manual

If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to
switch the appliance off by turning the selector dial to
. After a few
minutes the door can be opened ( pay attention to the water level
and temperature! ). After closing the door, it is necessary to select
the programme and options again and to press the button 6 .
7.1
7.2
7.3
Indicator pilot lights
•
When you start the programme by pressing the button 6 , the wash-
ing phase pilot light ( 7.1 ) illuminates. This means that the appli-
ance is operating.
•
This pilot light ( 7.2 ) illuminates when the appliance performs a
rinse or spin phase.
• When the programme has finished the end cycle pilot light ( 7.3 )
comes on.
At the end of the programme
The appliance stops automatically. The pilot light of
the button 6 and the pilot light corresponding to the
just finished washing phase go off. The light 7.3 illumi-
nates.
If a programme or an option that ends with water left
in the tub has been selected and the door remains
locked to indicate that the water must be emptied out
before opening the door.
Follow the below instructions to empty out the water:
•
Turn the programme selector dial to
.
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the
relevant button.
•
Press the button 6 .
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
to
switch the appliance off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not intend to
carry out another wash, close the water tap. Leave
the door open to prevent the formation of mildew and
unpleasant smells.
Warning! If there are children or pets in the
house, activate the child safety device in the
inner side of the door frame (for more details read "
Child safety" in the chapter "Safety Information").
Stand by : during programme setting up and
once the programme has finished, if the pro-
gramme selector dial and any button are not touched,
after a few minutes the energy saving system is ena-
bled. The pilot lights go off. The green pilot light of
the button 6 flashes with a low frequency. By press-
ing any button the appliance will come out of the ener-
gy saving status.
Door seal
At the end of every cy-
cle, check from the door
seal and remove objects
that could be trapped in
the fold.
16