User manual

Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not
level and stable.
Water inlet
Connect the hose to a
tap with a 3/4” thread.
35°
45°
Loosen the ring nut to angle the hose to the left or
right depending on the position of your water
tap. Do not place the inlet hose downwards. Af-
ter positioning the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
Water drainage
Firstly form a hook in the end of the drain hose us-
ing the plastic hose guide supplied with the appli-
ance .
The end of the drain hose can be positioned in four
ways:
•
Hooked over the edge of a sink using the plas-
tic hose guide.
Tie the plastic hose guide to the tap with a string to
prevent that the drain hose unhooks when the appli-
ance is emptying.
•
Onto a sink outlet spigot.
Push the drain hose onto the spigot and secure
with a clip, ensure a loop is formed in the drain
hose to prevent waste from the sink entering the ap-
pliance.
If the outlet spigot has not been used before, re-
move any blanking plug that may be in place.
•
Directly into a drain pipe at a height of not
less than 60 cm and not more than 100 cm.
8