User manual Fridge-Freezer ZKD1807
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 4 5 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 En
squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. • This appliance is heavy. Care should be taken when moving it.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
Thawing Movable shelves Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
• the freezing process takes 24 hours.
. Reload the previously removed food into the compartment. Important! Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life.
Problem Possible cause Solution The appliance has no power. There Connect a different electrical appliis no voltage in the mains socket. ance to the mains socket. Contact a qualified electrician. The lamp does not work. The compressor operates continually. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The temperature is not set correctly. Set a higher temperature. The door is not closed correctly. Refer to "Closing the door".
Problem Possible cause Solution The temperature regulator is not set Set a higher temperature. correctly. Replacing the lamp Caution! Disconnect the plug from the mains socket. 1. Remove the screw from the lamp cover. 2. Pull outwards the hook of the lamp cover. 3. Remove the lamp cover. 1 2 3 4. Replace the lamp with one of the same power (the maximum power is shown on the light bulb cover). 5. Install the lamp cover. 6. Tighten the screw to the lamp cover. 7. Connect the plug to the mains socket. 8.
1. Fit the spacers into the holes. Make sure that the arrow (A) is positioned as shown in the picture. 2. Turn counter-clockwise the spacers through 45° until they lock into place. Levelling A 45˚ When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front.
2 1 3 1. Remove the plug from 3. Remove the doors by the power socket. pulling them slightly and 2. Open the door of the remove the hinge. freezer. Loosen the hinge. 4. On the opposite side, remove the hole covers. 5. Unscrew both adjustable feet and the screws of the bottom door hinge. Remove the bottom door hinge and install it on the opposite side. 2 3 1 6. Unscrew the bottom far 7. Unscrew the top door side screw and install on holding pin. the opposite side. 11. Tighten the hinge.
Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, con- nect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
www.electrolux.
