IT Libretto Istruzioni 2 GB Instruction Manual 10 FR Manuel d’Instructions 18 DE Bedienungsanleitung 26 NL Gebruiksaanwijzing 34 Flexa
Dear Customer, If you follow the recommendations contained in this Instruction Manual, your appliance will give you constant high performance and will remain efficient for many years to come.
RECOMMENDATIONS AND SUGGESTIONS INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. • The minimum safety distance between the cooker top and the extractor hood is 650 mm. • Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. • For Class I appliances, check that the domestic power supply guarantees adequate earthing.
CHARACTERISTICS Dimensions 175 175 ø 120 280 0÷152 L Hood Type L 45 448 50 498 55 548 60 598 70 698 80 798 90 898 Components 12e Ref. 1 8 20 Q.ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Directional Air Outlet grille 1 Closing element Ref. 12a 12e Q.ty Installation Components 4 Screws 4,2 x 44,4 2 Screws 2,9 x 9,5 8 12a 1 20 GB Q.
INSTALLATION Drilling the Support surface and Fitting the Hood SCREW FITTING • The hood support surface must be 135 mm above the bottom surface of the wall units. • Drill the support with a ø 4.5 mm drill bit, using the drilling template provided. • Cut a hole ø 125 mm in size on the support surface, using the drilling template provided. • Fix using the 4 screws 12a (4,2 x 44,4) provided.
CLOSING ELEMENT • The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose. 20 Connections RECIRCULATION VERSION AIR OUTLET • Cut a hole ø 125 mm in the wall unit over the hood. • Connect the hood body outlet to the top part of the wall unit using a rigid or flexible pipe ø120 mm, to be selected by the installer. • Fix the pipe in position using sufficient pipe clamps (not supplied).
ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. • When opening the sliding carriage for the first time after installing the hood, pull it out briskly until it clicks.
MAINTENANCE Grease filters CLEANING METAL SELF-SUPPORTING GREASE FILTERS • The filters must be cleaned every two months of operation, or more frequently with heavy usage, and can be washed in a dishwasher. • Remove the filters one at a time, after disconnecting the relative fastening elements. • Wash the filters, taking care not to bend them. Allow them to dry before refitting. • When refitting the filters, make sure that the handle is visible on the outside.
Odour filters (Recirculation version) REPLACING ACTIVATED CHARCOAL FILTERS • These filters are not washable and cannot be regenerated, and must be replaced approximately every four months of operation, or more frequently with heavy usage. • Remove the metal grease filters, or open the filter retaining grill. • Remove the saturated activated carbon filters by releasing the fixing hooks. • Fit the new filters by hooking them into their seating.
Quest’apparecchio è conforme alla norma europea sulla bassa tensione C.E.E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C.E.E. 89/336 relativa alla compatibilità elettromagnetica e C.E.E. 93/68 relativa alla marcatura CE. This appliance conforms to European Low Voltage Directive 75/23/CEE governing electrical safety, European Directive 89/336/ CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking.
