DISHWASHER DA 6142 DA 6142 S 152969 91/0 Instruction Book UK
Description of the appliance 1. Upper basket stop 2. Water hardness switch 3. Salt container 4. Detergent dispenser (type A / type B) 5. Control panel 6. Rating plate 7. Rinse aid dispenser (type A / type B) 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket 12.
In daily use ● Check if it’s necessary to refill with special salt or rinse aid Loading cutlery and dishes ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. ● Before loading the dishes, you should: - Remove large left-overs.
Before closing the door, ensure that the spray arms can rotate freely. The cutlery basket is in two parts which can be separated to give greater loading flexibility. To separate the two parts, slide them horizontally in opposite directions and pull them apart. To reassemble, reverse the procedure. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position.
Washing programmes Programme Degree of soil and type of load Starting position of the programme selector dial Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) A Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Drying 110 - 120 1,15 - 1,24 16 - 18 95 - 105 1,15 - 1,24 13 - 15 (1) Intensive 65°c Heavy soil. Crockery, cutlery, pots and pans Normal 65°c Normal soil.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Service Force Centre by telephoning: Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. 08705 929929 Customer Care Department Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. - 600 820 570 600 IN05 Proceed as follows: Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.
From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. 14 billion USD in more than 150 countries around the world.
Instruction book - Part 1 Dishwasher Before use Maintenance Installation
Contents Safety instructions 2 Disposal 3 Economical and ecological dishwashing 3 Prior to using for the first time The water softener Setting the water softener Filling with salt Rinse aid Use of detergent 3 3 3 3 4 6 Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine 7 7 7 7 7 What to do, when...
For the disposing of the appliance please take it to a recycling centre or to your dealer who will, for a small contribution to the costs, dispose it for you. Disposal Dispose of the dishwasher packaging material correctly. All packaging materials can be recycled. Plastic parts are marked with standard international abbreviations: >PE< for polyethylene, e.g. sheet wrapping material. >PS< for polystyrene, e.g. padding material (always CFCfree). >POM< for polyoxymethylene, e.g. plastic clips.
Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the washing programmes (except the Rinse and Hold programme). This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
Filling with rinse aid Top up with rinse aid when: (Rinse aid dispenser type B) 1. The indicator (B) becomes clear, 1. Open the container by turning the lid (A) anticlockwise. 2. Fill with rinse aid exactly up to the level indicator marked "max". BR11 BR03 Ensure the lid is closed after every refill. 2. Only for dishwasher models with rinse aid indicator light: When the rinse aid indicator light on the control panel illuminates (when the machine is switched on).
Use of detergent Detergent tablets Only use detergents specifically designed for use in dishwashers. Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot develop their full cleaning power during short programmes. Therefore please use normal programmes with prewash when using detergent tablets. Using no more then the correct amount of detergent contributes to reducing pollution.
Maintenance and cleaning 8. Place the coarse/fine filter in the microfilter and press together. Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). 9. Put the filter combination in place and lock by turning the handle clockwise to the stop.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...there are problems when operating the dishwasher The dishwasher will not start or stops during operation. All push buttons are inoperative except for the On/Off push button. Press the On/Off push button to switch the dishwasher off and carry out the following suggested corrective actions.
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water outlet hose connection The end of the drain hose can be connected in the following ways: Remove all packaging before positioning the machine. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine.
Electrical connection This appliance must be earthed. The manufacturer declines any responsibility should this safety measure not be observed. The appliance should not be connected to the electrical supply by means of an extension cable. If the plug that is fitted to your appliance is not suitable for the socket, it must be cut off and the appropriate plug fitted.
152971 08/0 Subject to change without notice 0 01/03